Initialize the channel and band from mac80211 conf even when the FW is
not yet loaded. This mitigates a bug in AP-mode where the channel was
never changed from its initial setting after FW boot and was therefore
never configured to FW.
Reported-by: Alexander Boukaty <alexanderb@xxxxxx>
Signed-off-by: Arik Nemtsov <arik@xxxxxxxxxx>
---
drivers/net/wireless/wl12xx/main.c | 7 ++++++-
1 files changed, 6 insertions(+), 1 deletions(-)
diff --git a/drivers/net/wireless/wl12xx/main.c b/drivers/net/wireless/wl12xx/main.c
index 85cb4da..c262e60 100644
--- a/drivers/net/wireless/wl12xx/main.c
+++ b/drivers/net/wireless/wl12xx/main.c
@@ -1707,7 +1707,12 @@ static int wl1271_op_config(struct ieee80211_hw *hw, u32 changed)
mutex_lock(&wl->mutex);
if (unlikely(wl->state == WL1271_STATE_OFF)) {
- ret = -EAGAIN;
+ /* we support configuring the channel and band while off */
+ if ((changed & IEEE80211_CONF_CHANGE_CHANNEL)) {
+ wl->band = conf->channel->band;
+ wl->channel = channel;
+ }
+
goto out;
}
--
1.7.1
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
