On Tue, 2010-11-23 at 16:30 -0500, Josh Watts wrote:
> On Tue, 2010-11-23 at 21:13 +0200, Ido Yariv wrote:
> > On Tue, Nov 23, 2010 at 10:34:14AM -0500, Josh Watts wrote:
> > > I'm wondering if there's maybe some
> > > minor component or setting that I'm missing (like radio-enable, or
> > > perhaps limit to 802.11a, etc)?
> > Hi Josh,
> >
> > These kind of problems could be caused by using a wrong reference clock
> > value. Could you please double check that the reference clock
> > (board_ref_clock) matches the reference clock connected to the wl1271?
> >
> > Regards,
> > Ido.
>
> Does board_ref_clock refer to the SLOW_CLK signal fed to the TiWi board?
Oops, I see now I was confused on this point. It appears board_ref_clock
refers to the SDIO clock line, correct? It appears that my MMC/SDIO
interface is auto-configuring itself to 25MHz. Is this close enough to
26MHz, or do you think I should look into adjusting/forcing the
interface to operate at one of the rates listed in wl12xx/boot.c?
--
Josh Watts
ÿô.nlj·Ÿ®‰†+%ŠË±é¥Šwÿº{.nlj·¥Š{±ÿ«zW¬³ø¡Ü}©ž²ÆzÚj:+v‰¨þø®w¥þŠàÞ¨è&¢)ß«a¶Úÿûz¹ÞúŽŠÝjÿŠwèf
