2010/11/4 Gábor Stefanik <netrolller.3d@xxxxxxxxx>: > 2010/11/4 Henry Ptasinski <henryp@xxxxxxxxxxxx>: >> On 11/04/2010 07:39 AM, Gábor Stefanik wrote: >>> >>> On Thu, Nov 4, 2010 at 1:21 PM, Ariel Pedraza<pedrazaa@xxxxxxxxx> wrote: >>>> >>>> I have the 14e4:4727 and using the brcm80211, this is an example of what >>>> I get and the status of each commands: >>>> >>>> airmon-ng #ok >>>> airmon-ng stop wlan0 #ok >>>> ifconfig wlan0 #ok >>>> macchanger --mac yy:yy:yy:yy:yy:yy wlan0 #ok >>>> airmon-ng start wlan0 #ok >>>> airodump-ng mon0 #ok >>>> airodump-ng -c canal -w nomarch --bssid xx:xx:xx:xx:xx:xx mon0 #ok, no >>>> datas >>>> >>>> In other terminal: >>>> aireplay-ng -1 0 -a xx:xx:xx:xx:xx:xx -h yy:yy:yy:yy:yy:yy mon0 #ok, >>>> autentication succesful >>>> aireplay-ng -3 -b xx:xx:xx:xx:xx:xx -h yy:yy:yy:yy:yy:yy mon0 #ok, supose >>>> to increment datas but NOP!!! >>>> >>>> In other terminal: >>>> aircrack-ng -b xx:xx:xx:xx:xx:xx nomarch.cap #ok, no datas... >>>> >>>> So... when do you think that the brcm80211 implemetation will be ready to >>>> capture datas? >>> >>> Hmm... filter configuration issue? Apparently the "pass other-BSS >>> data" filter flag is not getting written to the hardware. (Do we even >>> have such a flag in the brcm80211 FW?) >> >>> >>> Can you see any data packets in Wireshark on the monitor interface? >> >> The following flags should all work with the brcm80211 FW: >> >> MCTL_KEEPBADFCS >> MCTL_KEEPCONTROL >> MCTL_PROMISC >> MCTL_BCNS_PROMISC >> >> The only one that's hooked up in the driver at the moment is >> MCTL_BCNS_PROMISC (for FIF_BCN_PRBRESP_PROMISC). I haven't taken a look at >> what it would take to enable monitor mode in the driver yet (setting up the >> monitor interface, etc). > > For raw monitor mode, all but KEEPBADFCS are needed. If the "fcsfail" > monitor mode flag is also set, KEEPBADFCS should be enabled too. > For cooked monitor, AFAIK only KEEPCONTROL (and perhaps BCNS_PROMISC) > are needed. > > However, do not set these based on interface type - use the FIF_ flags instead. BTW, please consider a KEEPBADPLCP flag in the next firmware release - it is needed for implementing the "plcpfail" monitor flag. > >> >> - Henry >> >> > > > > -- > Vista: [V]iruses, [I]ntruders, [S]pyware, [T]rojans and [A]dware. :-) > -- Vista: [V]iruses, [I]ntruders, [S]pyware, [T]rojans and [A]dware. :-) -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
