On 11/04/2010 07:39 AM, Gábor Stefanik wrote:
On Thu, Nov 4, 2010 at 1:21 PM, Ariel Pedraza<pedrazaa@xxxxxxxxx> wrote:
I have the 14e4:4727 and using the brcm80211, this is an example of what I get and the status of each commands:
airmon-ng #ok
airmon-ng stop wlan0 #ok
ifconfig wlan0 #ok
macchanger --mac yy:yy:yy:yy:yy:yy wlan0 #ok
airmon-ng start wlan0 #ok
airodump-ng mon0 #ok
airodump-ng -c canal -w nomarch --bssid xx:xx:xx:xx:xx:xx mon0 #ok, no datas
In other terminal:
aireplay-ng -1 0 -a xx:xx:xx:xx:xx:xx -h yy:yy:yy:yy:yy:yy mon0 #ok, autentication succesful
aireplay-ng -3 -b xx:xx:xx:xx:xx:xx -h yy:yy:yy:yy:yy:yy mon0 #ok, supose to increment datas but NOP!!!
In other terminal:
aircrack-ng -b xx:xx:xx:xx:xx:xx nomarch.cap #ok, no datas...
So... when do you think that the brcm80211 implemetation will be ready to capture datas?
Hmm... filter configuration issue? Apparently the "pass other-BSS
data" filter flag is not getting written to the hardware. (Do we even
have such a flag in the brcm80211 FW?)
>
> Can you see any data packets in Wireshark on the monitor interface?
The following flags should all work with the brcm80211 FW:
MCTL_KEEPBADFCS
MCTL_KEEPCONTROL
MCTL_PROMISC
MCTL_BCNS_PROMISC
The only one that's hooked up in the driver at the moment is
MCTL_BCNS_PROMISC (for FIF_BCN_PRBRESP_PROMISC). I haven't taken a look
at what it would take to enable monitor mode in the driver yet (setting
up the monitor interface, etc).
- Henry
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
