On Tue, Oct 26, 2010 at 07:40:47AM +0200, Helmut Schaa wrote: > > Please try to create a monitor interface on the rt73usb AP after setting it up: > > # iw dev wlan0 interface add mon0 type monitor > > and run a tcpdump on that (with XX:...:XX replaced by the MAC address of > your client): ip link set up dev mon0 > # tcpdump -i mon0 "ether src XX:XX:XX:XX:XX:XX" > > Do you see any frames from your specific client? On the client I run: zzz:~# ping 172.28.120.1 PING 172.28.120.1 (172.28.120.1) 56(84) bytes of data. >From 172.28.120.2 icmp_seq=1 Destination Host Unreachable >From 172.28.120.2 icmp_seq=2 Destination Host Unreachable >From 172.28.120.2 icmp_seq=3 Destination Host Unreachable On AP I get: # tcpdump -i mon0 "ether src 00:15:61:xx:xx:xx" tcpdump: WARNING: mon0: no IPv4 address assigned tcpdump: verbose output suppressed, use -v or -vv for full protocol decode listening on mon0, link-type IEEE802_11_RADIO (802.11 plus radiotap header), capture size 65535 bytes 00:02:51.398953 48.0 Mb/s 2447 MHz 11g -46dB signal antenna 1 [bit 14] Data IV: 56 Pad 20 KeyID 0 00:02:51.497845 48.0 Mb/s 2447 MHz 11g -46dB signal antenna 1 [bit 14] 00:02:52.415053 48.0 Mb/s 2447 MHz 11g -46dB signal antenna 1 [bit 14] Data IV: 57 Pad 20 KeyID 0 00:02:53.414897 48.0 Mb/s 2447 MHz 11g -46dB signal antenna 1 [bit 14] 00:02:53.415135 48.0 Mb/s 2447 MHz 11g -46dB signal antenna 1 [bit 14] Data IV: 58 Pad 20 KeyID 0 00:02:53.513661 48.0 Mb/s 2447 MHz 11g -44dB signal antenna 1 [bit 14] 00:02:54.415042 48.0 Mb/s 2447 MHz 11g -44dB signal antenna 1 [bit 14] Data IV: 59 Pad 20 KeyID 0 00:02:54.415671 36.0 Mb/s 2447 MHz 11g -44dB signal antenna 1 [bit 14] Data IV: 59 Pad 20 KeyID 0 00:02:54.513572 48.0 Mb/s 2447 MHz 11g -44dB signal antenna 1 [bit 14] 00:02:55.430725 48.0 Mb/s 2447 MHz 11g -46dB signal antenna 1 [bit 14] Data IV: 5a Pad 20 KeyID 0 00:02:56.430702 48.0 Mb/s 2447 MHz 11g -46dB signal antenna 1 [bit 14] 00:02:56.430942 48.0 Mb/s 2447 MHz 11g -46dB signal antenna 1 [bit 14] Data IV: 5b Pad 20 KeyID 0 00:02:56.529433 48.0 Mb/s 2447 MHz 11g -46dB signal antenna 1 [bit 14] 00:02:57.249028 1.0 Mb/s 2447 MHz 11b -44dB signal antenna 1 [bit 14] Probe Request (foo) [1.0 2.0 5.5 11.0 6.0 9.0 12.0 18.0 Mbit][|802.11] 00:02:57.350169 48.0 Mb/s 2447 MHz 11g -44dB signal antenna 1 [bit 14] 00:02:57.350402 24.0 Mb/s 2447 MHz 11g -44dB signal antenna 1 [bit 14] 00:02:57.350582 18.0 Mb/s 2447 MHz 11g -42dB signal antenna 1 [bit 14] ... (The client is sending ARP requests but not getting answer: zzz:~# tcpdump -p -i wlan0 tcpdump: verbose output suppressed, use -v or -vv for full protocol decode listening on wlan0, link-type EN10MB (Ethernet), capture size 65535 bytes 13:00:35.740957 ARP, Request who-has 172.28.120.1 tell 172.28.120.2, length 28 13:00:36.740924 ARP, Request who-has 172.28.120.1 tell 172.28.120.2, length 28 13:00:37.740926 ARP, Request who-has 172.28.120.1 tell 172.28.120.2, length 28 ) The station is using rt3070 usb dongle, AP is D-Link DWL-G122 rt73usb dongle. Johannes -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
