Juuso,
> -----Original Message-----
> Sent: Wednesday, October 06, 2010 12:36 AM
>
> On Wed, 2010-10-06 at 07:26 +0200, ext Gabay, Benzy wrote:
> > Juuso ,
> > I thought that there is no .ini in the 1271 MAC802.11 solution.
> > According to the code below you are deciding if it is "a" or not
> according to NVS file.
> >
> > Is it a typo in your header description or did I get it wrong?
>
> No typo, there is a configuration section inside the wl1271-nvs.bin
> -file referred to as the "INI-section." That ini section configures
> general parameters (including the dual-band support) and several
> radio-parameters.
Got it.
Thanks for the patient.
Benzy
>
> These INI-parameters are the only way for the driver to know whether
> there is 11a RF support in the hardware or not.
>
> -Juuso
>
> > > Sent: Monday, September 27, 2010 3:38 AM
> > >
> > > From: Juuso Oikarinen <juuso.oikarinen@xxxxxxxxx>
> > >
> > > Instead of hardcoding 11a support, enable/disable driver support
> based
> > > on
> > > the dual-mode-select parameter in the nvs-file general paramters.
> > >
> > > Signed-off-by: Juuso Oikarinen <juuso.oikarinen@xxxxxxxxx>
> > > Reviewed-by: Luciano Coelho <luciano.coelho@xxxxxxxxx>
> > > Signed-off-by: Luciano Coelho <luciano.coelho@xxxxxxxxx>
> > > ---
>
>
ÿô.nlj·Ÿ®‰†+%ŠË±é¥Šwÿº{.nlj·¥Š{±ÿ«zW¬³ø¡Ü}©ž²ÆzÚj:+v‰¨þø®w¥þŠàÞ¨è&¢)ß«a¶Úÿûz¹ÞúŽŠÝjÿŠwèf
