Am Montag 27 September 2010 schrieb Joshua Smith: > Sometimes my Linksys/Cisco WMP600N adapter will not initialize in AP mode. > Prior to going into AP mode, I do 'iw wlan0 scan' and get a bunch of info, > so the hardware is working up to that point. When I try to start hostapd, > I get this error in dmesg: > > phy0 -> rt2800_wait_wpdma_ready: Error - WPDMA TX/RX busy, aborting. > phy0 -> rt2800pci_set_device_state: Error - Device failed to enter state 4 (-5). Since you've scanned already before, I guess some DMA registers aren't reset correctly when taking the interface down. > (note that I also get this message: > phy0 -> rt2800pci_mcu_status: Error - MCU request failed, no response from hardware > but I get that when everything works, as well.) Yeah, that shouldn't be related. Helmut -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
