Hi, I'm running 2.6.35, and my wireless card fails to initialize properly on boot. I get the following messages in dmesg: [ 0.866525] ath5k 0000:02:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17 [ 0.866536] ath5k 0000:02:00.0: setting latency timer to 64 [ 0.866571] ath5k 0000:02:00.0: registered as 'phy0' [ 1.358241] ath: EEPROM regdomain: 0x67 [ 1.358242] ath: EEPROM indicates we should expect a direct regpair map [ 1.358245] ath: Country alpha2 being used: 00 [ 1.358247] ath: Regpair used: 0x67 [ 1.372021] ath5k phy0: can't register ieee80211 hw [ 1.372080] ath5k 0000:02:00.0: PCI INT A disabled [ 1.372084] ath5k: probe of 0000:02:00.0 failed with error -2 That said, if I remove the ath5k module, and modprobe ath5k, it starts working. [ 2976.411770] ath5k 0000:02:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17 [ 2976.411783] ath5k 0000:02:00.0: setting latency timer to 64 [ 2976.412767] ath5k 0000:02:00.0: registered as 'phy1' [ 2976.912422] ath: EEPROM regdomain: 0x67 [ 2976.912424] ath: EEPROM indicates we should expect a direct regpair map [ 2976.912427] ath: Country alpha2 being used: 00 [ 2976.912429] ath: Regpair used: 0x67 [ 2977.079190] ath5k phy1: Atheros AR2425 chip found (MAC: 0xe2, PHY: 0x70) Is this a known issue? -- Thomas Fjellstrom tfjellstrom@xxxxxxxxxxxxxxx -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
