On 02/26/10 15:26, Alban Browaeys wrote:
> After testing, we found that TX_STA_FIFO_MCS is the last MCS value
> tried. If the transmission failed, 8 frames have been transmitted. If the
> transmission succeed, we can easily compute the number of retry. This
> patch fix
> the way status is reported to mac80211 rate control. It has 2 bugs :
>
> 1. mcs can contain the short preamble flag and it will lead to wrong
> computations.
>
> 2. minstrel nearly always say that 54 Mbits is the best rate, even if we
> are
> very far from the AP
>
> TX_DONE_FALLBACK flag meaning has been changed : it means that a
> fallback rate table is used by the hardware.
>
> Signed-off-by: Benoit Papillault <benoit.papillault@xxxxxxx>
> ---
If you're submitting this patch, then please also add your Signed-off-by to this list.
Also, if I'm not mistaken, this one is on top of the previous patch you sent. Please indicate this
at patch submission time, so that John can apply patches in the correct order.
You can place such comments underneath the '---' marker in the patch, so that the message won't be
part of the upstream commit log.
Otherwise, the patch looks good, so just resubmit with the correct Sob, and the dependency mentioned.
> drivers/net/wireless/rt2x00/rt2800pci.c | 40 +++++++++++++--------
> drivers/net/wireless/rt2x00/rt2x00dev.c | 53
> ++++++++++++++++++++++++----
> drivers/net/wireless/rt2x00/rt2x00queue.h | 6 ++-
> 3 files changed, 74 insertions(+), 25 deletions(-)
>
> diff --git a/drivers/net/wireless/rt2x00/rt2800pci.c
> b/drivers/net/wireless/rt2x00/rt2800pci.c
> index 841f973..587c25d 100644
> --- a/drivers/net/wireless/rt2x00/rt2800pci.c
> +++ b/drivers/net/wireless/rt2x00/rt2800pci.c
> @@ -974,26 +974,36 @@ static void rt2800pci_txdone(struct rt2x00_dev
> *rt2x00dev)
> * Obtain the status about this packet.
> */
> txdesc.flags = 0;
> - if (rt2x00_get_field32(reg, TX_STA_FIFO_TX_SUCCESS))
> - __set_bit(TXDONE_SUCCESS, &txdesc.flags);
> - else
> - __set_bit(TXDONE_FAILURE, &txdesc.flags);
> + rt2x00_desc_read(txwi, 0, &word);
> + mcs = rt2x00_get_field32(word, TXWI_W0_MCS);
> + real_mcs = rt2x00_get_field32(reg, TX_STA_FIFO_MCS);
>
> /*
> * Ralink has a retry mechanism using a global fallback
> - * table. We setup this fallback table to try immediate
> - * lower rate for all rates. In the TX_STA_FIFO,
> - * the MCS field contains the MCS used for the successfull
> - * transmission. If the first transmission succeed,
> - * we have mcs == tx_mcs. On the second transmission,
> - * we have mcs = tx_mcs - 1. So the number of
> - * retry is (tx_mcs - mcs).
> + * table. We setup this fallback table to try the immediate
> + * lower rate for all rates. In the TX_STA_FIFO, the MCS field
> + * always contains the MCS used for the last transmission, be
> + * it successful or not.
> */
> - rt2x00_desc_read(txwi, 0, &word);
> - mcs = rt2x00_get_field32(word, TXWI_W0_MCS);
> - real_mcs = rt2x00_get_field32(reg, TX_STA_FIFO_MCS);
> + if (rt2x00_get_field32(reg, TX_STA_FIFO_TX_SUCCESS)) {
> + /*
> + * Transmission succeeded. The number of retries is
> + * mcs - real_mcs
> + */
> + __set_bit(TXDONE_SUCCESS, &txdesc.flags);
> + txdesc.retry = ((mcs > real_mcs) ? mcs - real_mcs : 0);
> + } else {
> + /*
> + * Transmission failed. The number of retries is
> + * always 7 in this case (for a total number of 8
> + * frames sent).
> + */
> + __set_bit(TXDONE_FAILURE, &txdesc.flags);
> + txdesc.retry = 7;
> + }
> +
> __set_bit(TXDONE_FALLBACK, &txdesc.flags);
> - txdesc.retry = mcs - min(mcs, real_mcs);
> +
>
> rt2x00lib_txdone(entry, &txdesc);
> }
> diff --git a/drivers/net/wireless/rt2x00/rt2x00dev.c
> b/drivers/net/wireless/rt2x00/rt2x00dev.c
> index b93731b..65259c6 100644
> --- a/drivers/net/wireless/rt2x00/rt2x00dev.c
> +++ b/drivers/net/wireless/rt2x00/rt2x00dev.c
> @@ -251,8 +251,7 @@ void rt2x00lib_txdone(struct queue_entry *entry,
>
> rate_idx = skbdesc->tx_rate_idx;
> rate_flags = skbdesc->tx_rate_flags;
> - retry_rates = test_bit(TXDONE_FALLBACK, &txdesc->flags) ?
> - (txdesc->retry + 1) : 1;
> + retry_rates = txdesc->retry + 1;
>
> /*
> * Initialize TX status
> @@ -265,13 +264,51 @@ void rt2x00lib_txdone(struct queue_entry *entry,
> * different rates to send out the frame, at each
> * retry it lowered the rate 1 step.
> */
> - for (i = 0; i < retry_rates && i < IEEE80211_TX_MAX_RATES; i++) {
> - tx_info->status.rates[i].idx = rate_idx - i;
> - tx_info->status.rates[i].flags = rate_flags;
> - tx_info->status.rates[i].count = 1;
> + if (test_bit(TXDONE_FALLBACK, &txdesc->flags)) {
> + /*
> + * Fill in a multiple rate entries, ie frame was sent once at
> + * each rates. We use rate_idx as an index into
> + * rt2x00_supported_rates array. Since we can have up to 8
> + * transmissions at different rates and since
> + * IEEE80211_TX_MAX_RATES is only 5, the array can be
> + * truncated.
> + */
> + for (i = 0; (i < retry_rates) &&
> + (i < IEEE80211_TX_MAX_RATES); i++) {
> + /*
> + * check if we reach the lowest rates for this
> + * modulation ie 1 Mbits for CCK and 6 Mbits for
> + * OFDM.
> + *
> + * FIXME : This code needs to be checked for MCS
> + */
> +
> + int idx = rate_idx - i;
> + if ((idx == 0) /* 1 Mbits CCK rate index */ ||
> + (idx == 4) /* 6 Mbits OFDM rate index */) {
> + tx_info->status.rates[i].idx = idx;
> + tx_info->status.rates[i].flags = rate_flags;
> + tx_info->status.rates[i].count =
> + retry_rates - i;
> + /* move to the next entry */
> + i++;
> + break;
> + } else {
> + tx_info->status.rates[i].idx = idx;
> + tx_info->status.rates[i].flags = rate_flags;
> + tx_info->status.rates[i].count = 1;
> + }
> + }
> + if (i < IEEE80211_TX_MAX_RATES)
> + tx_info->status.rates[i].idx = -1; /* terminate */
> + } else {
> + /* Fill in a single rate entry, ie frame was sent
> + * (txdesc->retry+1) times at the same rate */
> + tx_info->status.rates[0].idx = rate_idx;
> + tx_info->status.rates[0].flags = rate_flags;
> + tx_info->status.rates[0].count = retry_rates;
> + tx_info->status.rates[1].idx = -1; /* terminate */
> }
> - if (i < (IEEE80211_TX_MAX_RATES - 1))
> - tx_info->status.rates[i].idx = -1; /* terminate */
>
> if (!(tx_info->flags & IEEE80211_TX_CTL_NO_ACK)) {
> if (success)
> diff --git a/drivers/net/wireless/rt2x00/rt2x00queue.h
> b/drivers/net/wireless/rt2x00/rt2x00queue.h
> index c1e482b..4e801c3 100644
> --- a/drivers/net/wireless/rt2x00/rt2x00queue.h
> +++ b/drivers/net/wireless/rt2x00/rt2x00queue.h
> @@ -214,7 +214,7 @@ struct rxdone_entry_desc {
> *
> * @TXDONE_UNKNOWN: Hardware could not determine success of transmission.
> * @TXDONE_SUCCESS: Frame was successfully send
> - * @TXDONE_FALLBACK: Frame was successfully send using a fallback rate.
> + * @TXDONE_FALLBACK: Frame was sent using a fallback rate table.
> * @TXDONE_FAILURE: Frame was not successfully send
> * @TXDONE_EXCESSIVE_RETRY: In addition to &TXDONE_FAILURE, the
> * frame transmission failed due to excessive retries.
> @@ -234,7 +234,9 @@ enum txdone_entry_desc_flags {
> * after the device is done with transmission.
> *
> * @flags: TX done flags (See &enum txdone_entry_desc_flags).
> - * @retry: Retry count.
> + * @retry: Retry count. If TXDONE_FALLBACK is not set, the frame was sent
> + * (retry+1) times at the same rate. If TXDONE_FALLBACK is set, the
> frame was
> + * sent once for each lower rates, up to (retry+1) times in total.
> */
> struct txdone_entry_desc {
> unsigned long flags;
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
