From: Juuso Oikarinen <juuso.oikarinen@xxxxxxxxx>
Previously a "firmware chooses" value was used for the rates of all control
message templates set to the firmware. This resulted in a too high rate to be
chosen to transmit those messages. Change this by configuring a fixed low rate
for the templates.
Signed-off-by: Juuso Oikarinen <juuso.oikarinen@xxxxxxxxx>
Reviewed-by: Luciano Coelho <luciano.coelho@xxxxxxxxx>
Signed-off-by: Luciano Coelho <luciano.coelho@xxxxxxxxx>
---
drivers/net/wireless/wl12xx/wl1271_main.c | 3 ++-
1 files changed, 2 insertions(+), 1 deletions(-)
diff --git a/drivers/net/wireless/wl12xx/wl1271_main.c b/drivers/net/wireless/wl12xx/wl1271_main.c
index 8d090e4..a428fd2 100644
--- a/drivers/net/wireless/wl12xx/wl1271_main.c
+++ b/drivers/net/wireless/wl12xx/wl1271_main.c
@@ -78,7 +78,8 @@ static struct conf_drv_settings default_conf = {
.tx = {
.tx_energy_detection = 0,
.rc_conf = {
- .enabled_rates = CONF_TX_RATE_MASK_UNSPECIFIED,
+ .enabled_rates = CONF_HW_BIT_RATE_1MBPS |
+ CONF_HW_BIT_RATE_2MBPS,
.short_retry_limit = 10,
.long_retry_limit = 10,
.aflags = 0
--
1.6.3.3
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
