On 11/29/2009 05:59 PM, Gábor Stefanik wrote: > On Sun, Nov 29, 2009 at 3:01 PM, Tim Blechmann <tim-xpEK/MU0Hawdnm+yROfE0A@xxxxxxxxxxxxxxxx> wrote: >> On 11/04/2009 07:00 PM, Tim Blechmann wrote: >>>> running the rt61pci module on 2.6.31.5 works fine, but using the recent >>>> linus/master (2.6.32-rc5) results in this: >>> >>> same issue with 2.6.32-rc5 ... new bootlog with more debugging info >>> attached ... >> >> i was still able to reproduce this issue with 2.6.32-rc8 ... it would >> be nice, if someone could have a look into this issue before 2.6.32 is >> released ... >> >> dmesg from 2.6.32-rc8: >> [ 10.249098] rt61pci 0000:06:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16 >> [ 10.257182] phy0 -> rt61pci_validate_eeprom: EEPROM recovery - NIC: 0xff80 >> [ 10.257184] phy0 -> rt61pci_validate_eeprom: EEPROM recovery - Led: 0xe0ff >> [ 10.257187] phy0 -> rt2x00_set_chip: Info - Chipset detected - rt: 0302, rf: 0003, rev: 0002561c. >> [ 10.351794] Registered led device: rt61pci-phy0::radio >> [ 10.351839] Registered led device: rt61pci-phy0::assoc >> [ 14.342046] rt61pci 0000:06:00.0: firmware: requesting rt2561.bin >> [ 14.395533] phy0 -> rt2x00lib_request_firmware: Info - Firmware detected - version: 0.8. >> [ 14.421238] phy0 -> rt2x00mac_conf_tx: Info - Configured TX queue 0 - CWmin: 3, CWmax: 4, Aifs: 2, TXop: 102. >> [ 14.421245] phy0 -> rt2x00mac_conf_tx: Info - Configured TX queue 1 - CWmin: 4, CWmax: 5, Aifs: 2, TXop: 188. >> [ 14.421252] phy0 -> rt2x00mac_conf_tx: Info - Configured TX queue 2 - CWmin: 5, CWmax: 10, Aifs: 3, TXop: 0. >> [ 14.421258] phy0 -> rt2x00mac_conf_tx: Info - Configured TX queue 3 - CWmin: 5, CWmax: 10, Aifs: 7, TXop: 0. >> [ 273.404685] phy0 -> rt2x00queue_write_tx_frame: Error - Arrived at non-free entry in the non-full queue 2. >> [ 273.404687] Please file bug report to http://rt2x00.serialmonkey.com. >> [ 282.143549] wlan0: no IPv6 routers present >> [ 357.304908] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 2 >> [ 357.333806] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 9 >> [ 360.172776] phy0 -> rt2x00queue_write_tx_frame: Error - Arrived at non-free entry in the non-full queue 2. >> [ 360.172778] Please file bug report to http://rt2x00.serialmonkey.com. >> [ 360.172782] phy0 -> rt2x00mac_tx_rts_cts: Warning - Failed to send RTS/CTS frame. >> [ 383.880010] No probe response from AP 00:24:fe:09:94:18 after 500ms, disconnecting. >> [ 383.880026] phy0 -> rt2x00mac_conf_tx: Info - Configured TX queue 0 - CWmin: 2, CWmax: 3, Aifs: 2, TXop: 47. >> [ 383.880034] phy0 -> rt2x00mac_conf_tx: Info - Configured TX queue 1 - CWmin: 3, CWmax: 4, Aifs: 2, TXop: 94. >> [ 383.880042] phy0 -> rt2x00mac_conf_tx: Info - Configured TX queue 2 - CWmin: 4, CWmax: 10, Aifs: 3, TXop: 0. >> [ 383.880050] phy0 -> rt2x00mac_conf_tx: Info - Configured TX queue 3 - CWmin: 4, CWmax: 10, Aifs: 7, TXop: 0. >> [ 385.220460] wlan0: direct probe to AP 00:24:fe:09:94:18 (try 1) >> [ 385.421337] wlan0: direct probe to AP 00:24:fe:09:94:18 (try 2) >> [ 385.621304] wlan0: direct probe to AP 00:24:fe:09:94:18 (try 3) >> [ 385.821264] wlan0: direct probe to AP 00:24:fe:09:94:18 timed out >> >> >> lspci -vvv: >> >> 06:00.0 Network controller: RaLink RT2561/RT61 rev B 802.11g >> Subsystem: D-Link System Inc Device 3c09 >> Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR+ FastB2B- DisINTx- >> Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- >> Latency: 64, Cache Line Size: 64 bytes >> Interrupt: pin A routed to IRQ 16 >> Region 0: Memory at fb6f8000 (32-bit, non-prefetchable) [size=32K] >> Capabilities: [40] Power Management version 2 >> Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) >> Status: D0 PME-Enable- DSel=0 DScale=0 PME- >> Kernel driver in use: rt61pci >> Kernel modules: rt61pci >> >> thanks, tim > > Could you please try a bisect between 2.6.31 and 2.6.32-rc5? That > should reveal the faulty commit. > >> >> -- >> tim@xxxxxxxxxx >> http://tim.klingt.org >> >> Happiness is a byproduct of function, purpose, and conflict; those who >> seek happiness for itself seek victory without war. >> William S. Burroughs btw, on v2.6.31.6-rt19, i get the following messages continuously: [35097.254691] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 15 [35097.352620] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 21 [35097.400820] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 11 [35097.682924] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 17 [35098.050321] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 5 [35098.203187] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 23 [35098.390729] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 15 [35098.572894] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 15 [35098.735895] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 19 [35099.069564] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 7 [35099.407685] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 9 [35099.408726] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 13 [35099.417144] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 17 [35099.420996] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 21 [35099.518701] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 23 [35100.012178] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 11 [35101.354838] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 15 [35101.448263] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 7 [35101.498144] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 13 [35102.168253] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 9 [35102.548745] phy0 -> rt61pci_txdone: Warning - TX status report missed for entry 9 what does this tell me? i am not able to get any network connection with any 2.6.32-rc build, with (and without) the previously posted error messages tim -- tim@xxxxxxxxxx http://tim.klingt.org Who need fossil fuel when the sun ain't goin' nowhere Amiri Baraka
Attachment:
signature.asc
Description: OpenPGP digital signature
