Christian Lamparter wrote: > On Tuesday 16 December 2008 14:49:23 Artur Skawina wrote: >>> Dec 16 14:32:44 kernel: usb 1-7: new high speed USB device using ehci_hcd and address 14 >>> Dec 16 14:32:44 kernel: usb 1-7: configuration #1 chosen from 1 choice >>> Dec 16 14:32:44 kernel: usb 1-7: firmware: requesting isl3886usb >>> Dec 16 14:32:44 kernel: usb 1-7: New USB device found, idVendor=0846, idProduct=4200 >>> Dec 16 14:32:44 kernel: usb 1-7: New USB device strings: Mfr=0, Product=0, SerialNumber=0 >>> Dec 16 14:32:44 kernel: phy1: p54 detected a LM86 firmware >>> Dec 16 14:32:44 kernel: phy1: FW rev 2.5.6.0 - Softmac protocol 3.0 >>> Dec 16 14:32:44 kernel: phy1: you are using an obsolete firmware. visit http://wireless.kernel.org/en/users/Drivers/p54 and grab one for "kernel >= 2.6.28"! >>> Dec 16 14:32:44 kernel: phy1: cryptographic accelerator WEP:YES, TKIP:YES, CCMP:no >>> Dec 16 14:32:47 kernel: phy1: hwaddr 00:30:f1:12:34:56, MAC:isl3886 RF:Frisbee >>> Dec 16 14:32:47 kernel: phy1: Selected rate control algorithm 'minstrel' >>> Dec 16 14:32:47 kernel: usbcore: registered new interface driver p54usb >>> Dec 16 14:32:47 kernel: udev: renamed network interface wlan0 to wlan1 >> Did not do any further testing yet. > > Do the new firmwares work as well? > Because I'll dropping support for the old firmwares in the future. > The reason are bugs which can be triggered remotely... > (e.g.: frames with a "special" length etc...) I have not been using the old ones, so can't really compare them, but the newer one seems to work, at least a bit: kernel: usb 1-1.1: new full speed USB device using uhci_hcd and address 5 kernel: usb 1-1.1: configuration #1 chosen from 1 choice kernel: usb 1-1.1: firmware: requesting isl3886usb kernel: phy0: p54 detected a LM86 firmware kernel: p54: rx_mtu reduced from 3240 to 2392 kernel: phy0: FW rev 2.13.1.0 - Softmac protocol 5.5 kernel: phy0: cryptographic accelerator WEP:YES, TKIP:YES, CCMP:YES kernel: phy0: hwaddr 00:30:f1:12:34:56, MAC:isl3886 RF:Frisbee kernel: phy0: Selected rate control algorithm 'minstrel' kernel: usb 1-1.1: New USB device found, idVendor=0846, idProduct=4200 kernel: usb 1-1.1: New USB device strings: Mfr=0, Product=0, SerialNumber=0 so to test the device further i set up hostapd, which mostly worked; after a few tweaks (eg patching out country code setting in hostapd) i got an almost working AP. "Almost" because connecting a client works sometimes, but not always, and there seems to be way too much packet loss going on. "dtim_period=1" seemed to improve things enough to achieve basic ipv4 connectivity (w/o it dhcp seemed to work, but arp usually did not). But then i ran into a more serious issue -- the machine locks up completely when trying to use the device (just connecting and disconnecting a client is often enough). Happens after ~ a minute, the computer freezes, isn't responsible over network, nothing in logs. It's a headless box, tried hooking up a kbd and monitor, but that didn't help - console was dead too. After setting up netconsole i first got two skb truesize warnings [1], then after a short while again a complete lock up, nothing on the console. Then tried plugging in a keyboard and that provoked a stream of order 0 page allocation failures, but the machine remained dead. artur [1]: ------------[ cut here ]------------ WARNING: at net/core/skbuff.c:154 skb_truesize_bug+0x4c/0x50() SKB BUG: Invalid truesize (288) len=111, sizeof(sk_buff)=180 Modules linked in: netconsole saa7134_empress saa6752hs lnbp21 s5h1420 saa7134 budget videobuf_dma_sg budget_ci budget_core serio_raw videobuf_core tveeprom saa7146 ttpci_eeprom ir_common [last unloaded: microcode] Pid: 3797, comm: hostapd Not tainted 2.6.28-rc8-00519-g90435df #41 Call Trace: [<c0122f3f>] warn_slowpath+0x6f/0x90 [<c03b7efb>] __qdisc_run+0x1ab/0x200 [<c03a7f34>] dev_queue_xmit+0xd4/0x4e0 [<c04acb7a>] ieee80211_monitor_start_xmit+0x6a/0xa0 [<c03a7cda>] dev_hard_start_xmit+0x1aa/0x210 [<c03b7efb>] __qdisc_run+0x1ab/0x200 [<c03a7f34>] dev_queue_xmit+0xd4/0x4e0 [<c0241b38>] copy_to_user+0x38/0x130 [<c03a2bbc>] skb_truesize_bug+0x4c/0x50 [<c039df97>] sock_rfree+0x57/0x60 [<c03a1e76>] skb_release_head_state+0x36/0xb0 [<c03a12f8>] __kfree_skb+0x8/0x90 [<c03a39ea>] skb_free_datagram+0xa/0x30 [<c0452c25>] packet_recvmsg+0x1a5/0x200 [<c011cff3>] __wake_up_common+0x43/0x70 [<c039b2b7>] sock_recvmsg+0xd7/0x120 [<c0134d20>] autoremove_wake_function+0x0/0x50 [<c0241a02>] copy_from_user+0x32/0x130 [<c039c35e>] sys_recvfrom+0xce/0x160 [<c0107c26>] read_tsc+0x6/0x40 [<c029b85c>] pty_write+0x3c/0x60 [<c0293e5b>] tty_put_char+0x2b/0x40 [<c02972e4>] opost+0xd4/0x250 [<c0139eb1>] getnstimeofday+0x41/0xf0 [<c039c423>] sys_recv+0x33/0x40 [<c039c996>] sys_socketcall+0x196/0x290 [<c0103221>] sysenter_do_call+0x12/0x25 [<c04c0000>] cond_resched_softirq+0x50/0x60 ---[ end trace 9562176113d148b9 ]--- ------------[ cut here ]------------ WARNING: at net/core/skbuff.c:154 skb_truesize_bug+0x4c/0x50() SKB BUG: Invalid truesize (280) len=105, sizeof(sk_buff)=180 Modules linked in: netconsole saa7134_empress saa6752hs lnbp21 s5h1420 saa7134 budget videobuf_dma_sg budget_ci budget_core serio_raw videobuf_core tveeprom saa7146 ttpci_eeprom ir_common [last unloaded: microcode] Pid: 3797, comm: hostapd Tainted: G W 2.6.28-rc8-00519-g90435df #41 Call Trace: [<c0122f3f>] warn_slowpath+0x6f/0x90 [<c03b7efb>] __qdisc_run+0x1ab/0x200 [<c03a7f34>] dev_queue_xmit+0xd4/0x4e0 [<c04acb7a>] ieee80211_monitor_start_xmit+0x6a/0xa0 [<c03a7cda>] dev_hard_start_xmit+0x1aa/0x210 [<c03b7efb>] __qdisc_run+0x1ab/0x200 [<c03a7f34>] dev_queue_xmit+0xd4/0x4e0 [<c0241b38>] copy_to_user+0x38/0x130 [<c03a2bbc>] skb_truesize_bug+0x4c/0x50 [<c039df97>] sock_rfree+0x57/0x60 [<c03a1e76>] skb_release_head_state+0x36/0xb0 [<c03a12f8>] __kfree_skb+0x8/0x90 [<c03a39ea>] skb_free_datagram+0xa/0x30 [<c0452c25>] packet_recvmsg+0x1a5/0x200 [<c011cff3>] __wake_up_common+0x43/0x70 [<c039b2b7>] sock_recvmsg+0xd7/0x120 [<c0134d20>] autoremove_wake_function+0x0/0x50 [<c0241a02>] copy_from_user+0x32/0x130 [<c039c35e>] sys_recvfrom+0xce/0x160 [<c0107c26>] read_tsc+0x6/0x40 [<c029b85c>] pty_write+0x3c/0x60 [<c0293e5b>] tty_put_char+0x2b/0x40 [<c02972e4>] opost+0xd4/0x250 [<c0139eb1>] getnstimeofday+0x41/0xf0 [<c039c423>] sys_recv+0x33/0x40 [<c039c996>] sys_socketcall+0x196/0x290 [<c0103221>] sysenter_do_call+0x12/0x25 [<c04c0000>] cond_resched_softirq+0x50/0x60 ---[ end trace 9562176113d148b9 ]--- -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
