RTL8822CU, RTL8822BU, and RTL8821CU need an extra register write after reading and writing certain addresses. Without this, the firmware upload fails approximately more than 50% of the time. Tested with RTL8811CU (Tenda U9 V2.0) which is the same as RTL8821CU but without Bluetooth. Fixes: a82dfd33d123 ("wifi: rtw88: Add common USB chip support") Signed-off-by: Bitterblue Smith <rtl8821cerfe2@xxxxxxxxx> --- drivers/net/wireless/realtek/rtw88/usb.c | 46 ++++++++++++++++++++++++ 1 file changed, 46 insertions(+) diff --git a/drivers/net/wireless/realtek/rtw88/usb.c b/drivers/net/wireless/realtek/rtw88/usb.c index 3c4f28c306a9..ff01f7056ca9 100644 --- a/drivers/net/wireless/realtek/rtw88/usb.c +++ b/drivers/net/wireless/realtek/rtw88/usb.c @@ -33,6 +33,42 @@ static void rtw_usb_fill_tx_checksum(struct rtw_usb *rtwusb, rtw_tx_fill_txdesc_checksum(rtwdev, &pkt_info, skb->data); } +#define REG_ON_SEC 0x00 +#define REG_OFF_SEC 0x01 +#define REG_LOCAL_SEC 0x02 + +static void rtw_usb_reg_sec(struct rtw_dev *rtwdev, u32 addr, __le32 *data) +{ + struct rtw_usb *rtwusb = rtw_get_usb_priv(rtwdev); + struct usb_device *udev = rtwusb->udev; + u8 current_reg_sec; + u16 t_reg = 0x4e0; + u8 t_len = 1; + int status; + + if (addr < 0xFE00) { + if (addr <= 0xff) + current_reg_sec = REG_ON_SEC; + else if (0x1000 <= addr && addr <= 0x10ff) + current_reg_sec = REG_ON_SEC; + else + current_reg_sec = REG_OFF_SEC; + } else { + current_reg_sec = REG_LOCAL_SEC; + } + + if (current_reg_sec != REG_ON_SEC) + return; + + status = usb_control_msg(udev, usb_sndctrlpipe(udev, 0), + RTW_USB_CMD_REQ, RTW_USB_CMD_WRITE, + t_reg, 0, data, t_len, 500); + + if (status != t_len && status != -ENODEV) + rtw_err(rtwdev, "%s: reg 0x%x, usb write %u fail, status: %d\n", + __func__, t_reg, t_len, status); +} + static u32 rtw_usb_read(struct rtw_dev *rtwdev, u32 addr, u16 len) { struct rtw_usb *rtwusb = rtw_get_usb_priv(rtwdev); @@ -58,6 +94,11 @@ static u32 rtw_usb_read(struct rtw_dev *rtwdev, u32 addr, u16 len) rtw_err(rtwdev, "read register 0x%x failed with %d\n", addr, ret); + if (rtwdev->chip->id == RTW_CHIP_TYPE_8822C || + rtwdev->chip->id == RTW_CHIP_TYPE_8822B || + rtwdev->chip->id == RTW_CHIP_TYPE_8821C) + rtw_usb_reg_sec(rtwdev, addr, data); + return le32_to_cpu(*data); } @@ -111,6 +152,11 @@ static void rtw_usb_write(struct rtw_dev *rtwdev, u32 addr, u32 val, int len) if (ret < 0 && ret != -ENODEV && count++ < 4) rtw_err(rtwdev, "write register 0x%x failed with %d\n", addr, ret); + + if (rtwdev->chip->id == RTW_CHIP_TYPE_8822C || + rtwdev->chip->id == RTW_CHIP_TYPE_8822B || + rtwdev->chip->id == RTW_CHIP_TYPE_8821C) + rtw_usb_reg_sec(rtwdev, addr, data); } static void rtw_usb_write8(struct rtw_dev *rtwdev, u32 addr, u8 val) -- 2.43.2