When station is connected to a 6 GHz AP, it has 2 way to configure
the power limit to firmware. The first way is to send 2 wmi command
WMI_PDEV_PARAM_TXPOWER_LIMIT2G/WMI_PDEV_PARAM_TXPOWER_LIMIT5G to
firmware, the second way is to send WMI_VDEV_SET_TPC_POWER_CMDID to
firmware which include more parameters for power control.
The first way is disabled in previous patch
"ath11k: discard BSS_CHANGED_TXPOWER when EXT_TPC_REG_SUPPORT for 6 GHz".
Prepare the parameter for wmi command WMI_VDEV_SET_TPC_POWER_CMDID and
send the firmware after vdev start response success from firmware, it
is for the second way of power control.
Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-03125-QCAHSPSWPL_V1_V2_SILICONZ_LITE-3.6510.23
Signed-off-by: Wen Gong <quic_wgong@xxxxxxxxxxx>
---
drivers/net/wireless/ath/ath11k/mac.c | 8 +++++++-
1 file changed, 7 insertions(+), 1 deletion(-)
diff --git a/drivers/net/wireless/ath/ath11k/mac.c b/drivers/net/wireless/ath/ath11k/mac.c
index a8ae281d2635..f8b907a758b1 100644
--- a/drivers/net/wireless/ath/ath11k/mac.c
+++ b/drivers/net/wireless/ath/ath11k/mac.c
@@ -7296,6 +7296,12 @@ ath11k_mac_vdev_start_restart(struct ath11k_vif *arvif,
return ret;
}
+ if (ath11k_mac_supports_station_tpc(ar, arvif, chandef)) {
+ ath11k_mac_fill_reg_tpc_info(ar, arvif->vif, &arvif->chanctx);
+ ath11k_wmi_send_vdev_set_tpc_power(ar, arvif->vdev_id,
+ &arvif->reg_tpc_info);
+ }
+
if (!restart)
ar->num_started_vdevs++;
@@ -8108,7 +8114,7 @@ ath11k_mac_op_assign_vif_chanctx(struct ieee80211_hw *hw,
if (power_type == IEEE80211_REG_UNSET_AP)
power_type = IEEE80211_REG_LPI_AP;
ath11k_reg_handle_chan_list(ab, reg_info, power_type);
-
+ arvif->chanctx = *ctx;
ath11k_mac_parse_tx_pwr_env(ar, vif, ctx);
}
--
2.40.1
