ASUS USB-N13 C1 is a wifi adapter based on a RTL8192FU chip and its LED
doesn't blink with the rtl8xxxu driver. This patch fix this via writing
the correct value to the register "REG_LEDCFG0".
This was tested with these two wifi adapters:
ASUS USB-N13 C1 (vid=0x0b05, pid=0x18f1, rfe_type=0x1)
MERCURY MW310UH (vid=0x0bda, pid=0xf192, rfe_type=0x5)
Signed-off-by: Zenm Chen <zenmchen@xxxxxxxxx>
---
.../realtek/rtl8xxxu/rtl8xxxu_8192f.c | 24 ++++++++-----------
1 file changed, 10 insertions(+), 14 deletions(-)
diff --git a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_8192f.c b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_8192f.c
index 28e93835e05a..ab6d4e4e228e 100644
--- a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_8192f.c
+++ b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_8192f.c
@@ -2014,26 +2014,22 @@ static int rtl8192fu_led_brightness_set(struct led_classdev *led_cdev,
struct rtl8xxxu_priv *priv = container_of(led_cdev,
struct rtl8xxxu_priv,
led_cdev);
- u16 ledcfg;
+ u32 ledcfg;
/* Values obtained by observing the USB traffic from the Windows driver. */
rtl8xxxu_write32(priv, REG_SW_GPIO_SHARE_CTRL_0, 0x20080);
rtl8xxxu_write32(priv, REG_SW_GPIO_SHARE_CTRL_1, 0x1b0000);
- ledcfg = rtl8xxxu_read16(priv, REG_LEDCFG0);
-
- if (brightness == LED_OFF) {
- /* Value obtained like above. */
- ledcfg = BIT(1) | BIT(7);
- } else if (brightness == LED_ON) {
- /* Value obtained like above. */
- ledcfg = BIT(1) | BIT(7) | BIT(11);
- } else if (brightness == RTL8XXXU_HW_LED_CONTROL) {
- /* Value obtained by brute force. */
- ledcfg = BIT(8) | BIT(9);
- }
+ /* Enable LED0 GPIO and turn LED0/LED1 off. */
+ ledcfg = (rtl8xxxu_read32(priv, REG_LEDCFG0) | BIT(21)) & ~0xffff;
+
+ /* Values obtained by brute force. */
+ if (brightness == LED_ON)
+ ledcfg |= BIT(3) | BIT(11);
+ else if (brightness == RTL8XXXU_HW_LED_CONTROL)
+ ledcfg |= BIT(0) | BIT(1) | BIT(8) | BIT(9);
- rtl8xxxu_write16(priv, REG_LEDCFG0, ledcfg);
+ rtl8xxxu_write32(priv, REG_LEDCFG0, ledcfg);
return 0;
}
--
2.42.0
