On 27/03/2023 19:08, Martin Kaistra wrote:
> Am 27.03.23 um 15:10 schrieb Bitterblue Smith:
>> On 22/03/2023 19:18, Martin Kaistra wrote:
>>> This gets called at the start of AP mode operation. Set bssid, beacon
>>> interval and send a connect report to the HW.
>>>
>>
>> Hmm, but why send a connect report when you don't have anything
>> connected yet?
>
> I tried following the vendor driver here, I don't know what exactly happens in the firmware.
> I can test, though, if there is any difference, if I remove it.
>
Ah, okay. I was just wondering.
>>
>>> Signed-off-by: Martin Kaistra <martin.kaistra@xxxxxxxxxxxxx>
>>> ---
>>> .../net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c | 15 +++++++++++++++
>>> 1 file changed, 15 insertions(+)
>>>
>>> diff --git a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c
>>> index c152b228606f1..90b98b9dcbd9d 100644
>>> --- a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c
>>> +++ b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_core.c
>>> @@ -4899,6 +4899,20 @@ rtl8xxxu_bss_info_changed(struct ieee80211_hw *hw, struct ieee80211_vif *vif,
>>> return;
>>> }
>>> +static int rtl8xxxu_start_ap(struct ieee80211_hw *hw, struct ieee80211_vif *vif,
>>> + struct ieee80211_bss_conf *link_conf)
>>> +{
>>> + struct rtl8xxxu_priv *priv = hw->priv;
>>> + struct device *dev = &priv->udev->dev;
>>> +
>>> + dev_dbg(dev, "Start AP mode\n");
>>> + rtl8xxxu_set_bssid(priv, vif->bss_conf.bssid);
>>> + rtl8xxxu_write16(priv, REG_BCN_INTERVAL, vif->bss_conf.beacon_int);
>>> + priv->fops->report_connect(priv, 0, true);
>>> +
>>> + return 0;
>>> +}
>>> +
>>> static u32 rtl8xxxu_80211_to_rtl_queue(u32 queue)
>>> {
>>> u32 rtlqueue;
>>> @@ -7026,6 +7040,7 @@ static const struct ieee80211_ops rtl8xxxu_ops = {
>>> .config = rtl8xxxu_config,
>>> .conf_tx = rtl8xxxu_conf_tx,
>>> .bss_info_changed = rtl8xxxu_bss_info_changed,
>>> + .start_ap = rtl8xxxu_start_ap,
>>> .configure_filter = rtl8xxxu_configure_filter,
>>> .set_rts_threshold = rtl8xxxu_set_rts_threshold,
>>> .start = rtl8xxxu_start,
>>
