On 11/24/22 09:42, Arend van Spriel wrote:
On 11/18/2022 6:41 AM, Andy Green wrote:
On 11/17/22 21:52, Arend Van Spriel wrote:
I see. So could you load bcmdhd and provide log. Preferably with
higher debug level. It also has a module parameter for it. I think it
is called dhd_msg_level and please set it to 0x817.
It's here:
https://warmcat.com/ap6275p-dhd-log1.txt
Hi Andy,
Thanks for the log. Together with the dhd driver sources I could make
some sense of it. Perhaps you can try the following hack and see if we
make it over the first hurdle.
OH! I found that the line below should be count, not sizeof(count).
+ addr -= sizeof(count);
+ memcpy_toio(devinfo->tcm + addr, seed, count);
+}
With that, you were right on the money, the firmware comes up
[ 3.796062] brcmfmac: brcmf_c_preinit_dcmds: Firmware: BCM43752/2
wl0: Jul 12 2022 18:54:54 version 18.35.387.23.146 (g412cc5ec) FWID
01-93c53be6
along with
wlP2p33s0: flags=4098<BROADCAST,MULTICAST> mtu 1500
ether d4:9c:dd:f5:bf:7e txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
I will try get it to scan...
... any way, good job!
-Andy
