Search Linux Wireless

Re: [PATCH v4 2/2] wilc1000: Document enable-gpios and reset-gpios properties

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Tue, 2021-12-14 at 14:04 -0600, Rob Herring wrote:
> On Tue, 14 Dec 2021 16:33:22 +0000, David Mosberger-Tang wrote:
> > Add documentation for the ENABLE and RESET GPIOs that may be needed by
> > wilc1000-spi.
> > 
> > Signed-off-by: David Mosberger-Tang <davidm@xxxxxxxxxx>
> > ---
> >  .../net/wireless/microchip,wilc1000.yaml        | 17 +++++++++++++++++
> >  1 file changed, 17 insertions(+)
> > 
> 
> My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check'
> on your patch (DT_CHECKER_FLAGS is new in v5.13):
> 
> yamllint warnings/errors:
> 
> dtschema/dtc warnings/errors:
> Error: Documentation/devicetree/bindings/net/wireless/microchip,wilc1000.example.dts:30.37-38 syntax error
> FATAL ERROR: Unable to parse input tree
> make[1]: *** [scripts/Makefile.lib:373: Documentation/devicetree/bindings/net/wireless/microchip,wilc1000.example.dt.yaml] Error 1
> make[1]: *** Waiting for unfinished jobs....
> make: *** [Makefile:1413: dt_binding_check] Error 2

So this error appears due to GPIO_ACTIVE_HIGH and GPIO_ACTIVE_LOW in these
lines:

        enable-gpios = <&pioA 5 GPIO_ACTIVE_HIGH>;
        reset-gpios = <&pioA 6 GPIO_ACTIVE_LOW>;

I can replace those with 0 and 1 respectively, but I doubt a lot of people would
recognize what those integers standard for.  Is there a better way to get this
to pass?

  --david




[Index of Archives]     [Linux Host AP]     [ATH6KL]     [Linux Wireless Personal Area Network]     [Linux Bluetooth]     [Wireless Regulations]     [Linux Netdev]     [Kernel Newbies]     [Linux Kernel]     [IDE]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite Hiking]     [MIPS Linux]     [ARM Linux]     [Linux RAID]

  Powered by Linux