Search Linux Wireless

Re: [PATCH 1/2] wcn36xx: Correct band/freq reporting on RX

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Loic Poulain <loic.poulain@xxxxxxxxxx> wrote:

> For packets originating from hardware scan, the channel and band is
> included in the buffer descriptor (bd->rf_band & bd->rx_ch).
> 
> For 2Ghz band the channel value is directly reported in the 4-bit
> rx_ch field. For 5Ghz band, the rx_ch field contains a mapping
> index (given the 4-bit limitation).
> 
> The reserved0 value field is also used to extend 4-bit mapping to
> 5-bit mapping to support more than 16 5Ghz channels.
> 
> This change adds correct reporting of the frequency/band, that is
> used in scan mechanism. And is required for 5Ghz hardware scan
> support.
> 
> Signed-off-by: Loic Poulain <loic.poulain@xxxxxxxxxx>
> Tested-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
> Signed-off-by: Kalle Valo <kvalo@xxxxxxxxxxxxxx>

2 patches applied to ath-next branch of ath.git, thanks.

8a27ca394782 wcn36xx: Correct band/freq reporting on RX
2371b15f8eeb wcn36xx: Enable hardware scan offload for 5Ghz band

-- 
https://patchwork.kernel.org/project/linux-wireless/patch/1634554678-7993-1-git-send-email-loic.poulain@xxxxxxxxxx/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches




[Index of Archives]     [Linux Host AP]     [ATH6KL]     [Linux Wireless Personal Area Network]     [Linux Bluetooth]     [Wireless Regulations]     [Linux Netdev]     [Kernel Newbies]     [Linux Kernel]     [IDE]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite Hiking]     [MIPS Linux]     [ARM Linux]     [Linux RAID]

  Powered by Linux