[PATCH v2 10/11] wilc1000: use correct write command sequence in wilc_spi_sync_ext()

[<Ajay.Kathat@xxxxxxxxxxxxx>]

From: Ajay Singh <ajay.kathat@xxxxxxxxxxxxx>

Instead of using double read for the same register, use the write register
command after the read command.
The correct sequence is to use the read value in write command instead of
reading the same register again.

Signed-off-by: Ajay Singh <ajay.kathat@xxxxxxxxxxxxx>
---
 drivers/net/wireless/microchip/wilc1000/spi.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/wireless/microchip/wilc1000/spi.c b/drivers/net/wireless/microchip/wilc1000/spi.c
index 4f0bc24d2a78..640850f989dd 100644
--- a/drivers/net/wireless/microchip/wilc1000/spi.c
+++ b/drivers/net/wireless/microchip/wilc1000/spi.c
@@ -1167,7 +1167,7 @@ static int wilc_spi_sync_ext(struct wilc *wilc, int nint)
 		for (i = 0; (i < 3) && (nint > 0); i++, nint--)
 			reg |= BIT(i);
 
-		ret = wilc_spi_read_reg(wilc, WILC_INTR2_ENABLE, &reg);
+		ret = wilc_spi_write_reg(wilc, WILC_INTR2_ENABLE, reg);
 		if (ret) {
 			dev_err(&spi->dev, "Failed write reg (%08x)...\n",
 				WILC_INTR2_ENABLE);
-- 
2.25.1