From: Ajay Singh <ajay.kathat@xxxxxxxxxxxxx>
The series contains following patches:
- add chip wakeup sequence support required for PS mode
- new WID to handle passing of WOWLan info to FW
- add reset command support for WILC SPI bus
- few trivial fixes for WILC SPI
Changes in v2:
- updated commit details to address the review comments
- used pr_debug instead of pr_info in patch#8
- removed patch#9 as those changes already merged to mainline
Ajay Singh (11):
wilc1000: move 'deinit_lock' lock init/destroy inside module probe
wilc1000: fix possible memory leak in cfg_scan_result()
wilc1000: add new WID to pass wake_enable information to firmware
wilc1000: configure registers to handle chip wakeup sequence
wilc1000: add reset/terminate/repeat command support for SPI bus
wilc1000: handle read failure issue for clockless registers
wilc1000: ignore clockless registers status response for SPI
wilc1000: invoke chip reset register before firmware download
wilc1000: add 'initialized' flag check before adding an element to TX
queue
wilc1000: use correct write command sequence in wilc_spi_sync_ext()
wilc1000: increase config packets response wait timeout limit
.../wireless/microchip/wilc1000/cfg80211.c | 11 +-
drivers/net/wireless/microchip/wilc1000/hif.c | 31 +++-
drivers/net/wireless/microchip/wilc1000/hif.h | 1 +
.../net/wireless/microchip/wilc1000/netdev.h | 2 -
.../net/wireless/microchip/wilc1000/sdio.c | 1 +
drivers/net/wireless/microchip/wilc1000/spi.c | 91 +++++++++++-
.../net/wireless/microchip/wilc1000/wlan.c | 134 +++++++++++-------
.../net/wireless/microchip/wilc1000/wlan.h | 5 +-
.../wireless/microchip/wilc1000/wlan_cfg.c | 1 +
.../net/wireless/microchip/wilc1000/wlan_if.h | 7 +-
10 files changed, 210 insertions(+), 74 deletions(-)
--
2.25.1
