On 2020-09-17 20:48, Kalle Valo wrote:
Venkateswara Naralasetty <vnaralas@xxxxxxxxxxxxxx> writes:
Adding raw mode tx/rx support. Also, adding support
for software crypto which depends on raw mode.
To enable raw mode tx/rx:
insmod ath11k.ko frame_mode=0
To enable software crypto:
insmod ath11k.ko crypto_mode=1
These modes could be helpful in debugging crypto related issues.
Tested-on: IPQ8074 WLAN.HK.2.1.0.1-01228-QCAHKSWPL_SILICONZ-1
Signed-off-by: Manikanta Pubbisetty <mpubbise@xxxxxxxxxxxxxx>
Signed-off-by: Venkateswara Naralasetty <vnaralas@xxxxxxxxxxxxxx>
[...]
--- a/drivers/net/wireless/ath/ath11k/wmi.c
+++ b/drivers/net/wireless/ath/ath11k/wmi.c
@@ -3366,6 +3366,10 @@ int ath11k_wmi_cmd_init(struct ath11k_base *ab)
config.rx_timeout_pri[2] = TARGET_RX_TIMEOUT_LO_PRI;
config.rx_timeout_pri[3] = TARGET_RX_TIMEOUT_HI_PRI;
config.rx_decap_mode = TARGET_DECAP_MODE_NATIVE_WIFI;
+
+ if (test_bit(ATH11K_FLAG_RAW_MODE, &ab->dev_flags))
+ config.rx_decap_mode = TARGET_DECAP_MODE_RAW;
Did you test this at all? Because to me it looks like in
ath11k_init_wmi_config_ipq8074() this is overwritten with:
config->rx_decap_mode = TARGET_DECAP_MODE_NATIVE_WIFI;
So I can't see how this would even work. I noticed this while I was
cleaning up ath11k_wmi_cmd_init(). I'll send a patch soon, please test
that and let me know if it works.
My bad it seems my tree is bit older, sorry for the confusion.
Also I noticed, .wmi_init_config of ipq8074_ops is registered with "
ath11k_init_wmi_config_qca6390()" Is that correct?
If that is correct, then I don't see ath11k_init_wmi_config_ipq8074()
is called from any other place.
I will send one patch to fix this issue. Please correct me if I am
wrong.
