Hello Tamizh, > Add TID specific Tx bitrate configuration by using > handle_bitrates already APIs. > > Examples: > $ iw dev wlan0 peer xx:xx:xx:xx:xx:xx tids 0x2 bitrates auto > $ iw dev wlan0 peer xx:xx:xx:xx:xx:xx tids 0x2 bitrates limit vht-mcs-5 4:9 > > Signed-off-by: Tamizh Chelvam <tamizhr@xxxxxxxxxxxxxx> > --- > bitrate.c | 27 ++++++++++++++++++++------- > interface.c | 34 +++++++++++++++++++++++++++++++++- > iw.h | 3 +++ > 3 files changed, 56 insertions(+), 8 deletions(-) ... > COMMAND(set, tidconf, "[peer <MAC address>] tids <mask> [override] [sretry <num>] [lretry <num>] " > - "[ampdu [on|off]] [amsdu [on|off]] [noack [on|off]] [rtscts [on|off]]", > + "[ampdu [on|off]] [amsdu [on|off]] [noack [on|off]] [rtscts [on|off]]" > + "[bitrates <type [auto|fixed|limit]> [legacy-<2.4|5> <legacy rate in Mbps>*] [ht-mcs-<2.4|5> <MCS index>*]" > + " [vht-mcs-<2.4|5> <NSS:MCSx,MCSy... | NSS:MCSx-MCSy>*] [sgi-2.4|lgi-2.4] [sgi-5|lgi-5]]", > NL80211_CMD_SET_TID_CONFIG, 0, CIB_NETDEV, handle_tid_config, > "Setup per-node TID specific configuration for TIDs selected by bitmask.\n" > "If MAC address is not specified, then supplied TID configuration\n" > @@ -955,4 +985,6 @@ COMMAND(set, tidconf, "[peer <MAC address>] tids <mask> [override] [sretry <num> > " $ iw dev wlan0 tids 0x5 ampdu off amsdu off rtscts on\n" > " $ iw dev wlan0 tids 0x3 override ampdu on noack on rtscts on\n" > " $ iw dev wlan0 peer xx:xx:xx:xx:xx:xx tids 0x1 ampdu off tids 0x3 amsdu off rtscts on\n" > + " $ iw dev wlan0 peer xx:xx:xx:xx:xx:xx tids 0x2 bitrates auto\n" > + " $ iw dev wlan0 peer xx:xx:xx:xx:xx:xx tids 0x2 bitrates limit vht-mcs-5 4:9\n" It just occured to me that I wrote incorrect help message in the patch adding tidconf command. IIRC the correct usage should be: $ iw dev wlan0 set tidconf peer 1:2:3:4:5:6 tids 0x3 ampdu off tids 0x2 sretry 10 lretry 100 $ iw dev wlan0 set tidconf tids 0xff ampdu off amsdu off sretry 10 lretry 100 noack off Could you please update new help entries and fix the existing ones ? Regards, Sergey
