> [root@dhcp-27-155 ~]# iw dev
> phy#1
> Interface wlan1
> ifindex 10
> wdev 0x100000001
> addr 2c:4d:54:cb:d8:04
> type managed
> [root@dhcp-27-155 ~]# ip link set addres b0:6e:bf:a5:31:90 wlan1
> [root@dhcp-27-155 ~]# iw dev wlan1 del
> [root@dhcp-27-155 ~]# iw phy phy0 interface add wlan0 type station
> command failed: No such file or directory (-2)
> [root@dhcp-27-155 ~]# iw phy phy1 interface add wlan0 type station
> [root@dhcp-27-155 ~]# iw dev
> phy#1
> Interface wlan0
> ifindex 11
> wdev 0x100000002
> addr 2c:4d:54:cb:d8:04
> type managed
> [root@dhcp-27-155 ~]# ethtool -i wlan0
> driver: mt76x2u
> version: 4.20.0-rc1+
> firmware-version: 0.0.00-b1
> bus-info: 1-1.2:1.0
> supports-statistics: yes
> supports-test: no
> supports-eeprom-access: no
> supports-register-dump: no
> supports-priv-flags: no
>
> Anyway I think, to support MAC address change, we should not filter
> based on MAC address, but maybe only on BSSID ?
>
> Thanks
> Stanislaw
You can create the interface with a given mac address
# iw phy phy0 interface add wlp0s4u1 type managed addr 00:11:22:33:44:55
# iw dev
phy#0
Interface wlp0s4u1
ifindex 9
wdev 0x2
addr 00:11:22:33:44:55
type managed
txpower 3.00 dBm
# ip link show dev wlp0s4u1
9: wlp0s4u1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP mode DORMANT group default qlen 1000
link/ether 00:11:22:33:44:55 brd ff:ff:ff:ff:ff:ff
Regards,
Lorenzo
