Govind Singh <govinds@xxxxxxxxxxxxxx> writes: > Add QMI client driver for Q6 integrated WLAN connectivity subsystem. > This module is responsible for communicating WLAN control messages to FW > over QMI interface. > > “QUALCOMM Messaging Interface”(QMI) provides the control interface between > components running b/w remote processors with underlying transport layer > based on integrated chipset(shared memory) or discrete chipset(PCI/USB/SDIO/UART). > > QMI client driver implementation is based on qmi frmework https://lwn.net/Articles/729924/. > > Below is the sequence of qmi handshake. > > QMI CLIENT(APPS) QMI SERVER(FW in Q6) > > <------wlan service discoverd---- > > -----connect to wlam qmi service-----> > > ------------wlan info request-----> > > <------------wlan info resp------------ > > ------------msa info req--------> > > <------------msa info resp------------ > > ------------msa ready req--------> > > <------------msa ready resp------------ > > <------------msa ready indication------- > > ------------capability req-------> > > <------------capability resp------------ > > ------------qmi bdf req---------> > > <------------qmi bdf resp------------ > > ------------qmi cal trigger-------> > > <------------ QMI FW ready indication------- > > Govind Singh (12): > ath10k: Add qmi service for wlan qmi client > dt: bindings: add bindings for ath10k qmi client > ath10k: Add WCN3990 QMI client driver > ath10k: add support to start and stop qmi service > ath10k: Add support of QMI indication message > firmware: qcom: scm: Add WLAN VMID for Qualcomm SCM interface > ath10k: Add MSA handshake QMI mgs support > ath10k: Add QMI CAP request support > ath10k: Add QMI HOST CAP request support > ath10k: add bdf/cal indication support > ath10k: Add wlan mode on/off qmi message > ath10k: Add qmi wlan enable/disable support for WCN3990 BTW, I noticed that you had v3 only in the cover letter but the version number should be in every patch part of the set: https://patchwork.kernel.org/patch/10307161/ -- Kalle Valo
