If driver is loaded with 'mfg_mode' enabled, then the sending
commands are not allowed. So, skip sending commands, to firmware
in mwifiex_add_virtual_intf if 'mfg_mode' is enabled.
Fixes: 7311ea850079 ("mwifiex: fix AP start problem for newly added interface")
Signed-off-by: Ganapathi Bhat <gbhat@xxxxxxxxxxx>
---
v2: addressed Brian's comments.
---
drivers/net/wireless/marvell/mwifiex/cfg80211.c | 19 +++++++++++--------
1 file changed, 11 insertions(+), 8 deletions(-)
diff --git a/drivers/net/wireless/marvell/mwifiex/cfg80211.c b/drivers/net/wireless/marvell/mwifiex/cfg80211.c
index 32c5074..ad1ebd8 100644
--- a/drivers/net/wireless/marvell/mwifiex/cfg80211.c
+++ b/drivers/net/wireless/marvell/mwifiex/cfg80211.c
@@ -2959,18 +2959,21 @@ struct wireless_dev *mwifiex_add_virtual_intf(struct wiphy *wiphy,
}
mwifiex_init_priv_params(priv, dev);
- mwifiex_set_mac_address(priv, dev);
priv->netdev = dev;
- ret = mwifiex_send_cmd(priv, HostCmd_CMD_SET_BSS_MODE,
- HostCmd_ACT_GEN_SET, 0, NULL, true);
- if (ret)
- goto err_set_bss_mode;
+ if (!adapter->mfg_mode) {
+ mwifiex_set_mac_address(priv, dev);
- ret = mwifiex_sta_init_cmd(priv, false, false);
- if (ret)
- goto err_sta_init;
+ ret = mwifiex_send_cmd(priv, HostCmd_CMD_SET_BSS_MODE,
+ HostCmd_ACT_GEN_SET, 0, NULL, true);
+ if (ret)
+ goto err_set_bss_mode;
+
+ ret = mwifiex_sta_init_cmd(priv, false, false);
+ if (ret)
+ goto err_sta_init;
+ }
mwifiex_setup_ht_caps(&wiphy->bands[NL80211_BAND_2GHZ]->ht_cap, priv);
if (adapter->is_hw_11ac_capable)
--
1.9.1
