On Wed, 2017-01-11 at 23:33 +0100, Felix Fietkau wrote: > ibss and mesh modes copy the ht capabilites from the band without > overriding the SMPS state. Unfortunately the default value 0 for the > SMPS field means static SMPS instead of disabled. > > This results in HT ibss and mesh setups using only single-stream > rates, > even though SMPS is not supposed to be active. > > Initialize SMPS to disabled for all bands on ieee80211_hw_register to > ensure that the value is sane where it is not overriden with the real > SMPS state. Hmm. I guess the only other place affected by it will be scanning? > Reported-by: Elektra Wagenrad <onelektra@xxxxxxx> > Signed-off-by: Felix Fietkau <nbd@xxxxxxxx> > --- > net/mac80211/main.c | 13 +++++++++---- > 1 file changed, 9 insertions(+), 4 deletions(-) > > diff --git a/net/mac80211/main.c b/net/mac80211/main.c > index 1822c77f2b1c..c269046aa02b 100644 > --- a/net/mac80211/main.c > +++ b/net/mac80211/main.c > @@ -913,10 +913,15 @@ int ieee80211_register_hw(struct ieee80211_hw > *hw) > supp_ht = supp_ht || sband->ht_cap.ht_supported; > supp_vht = supp_vht || sband->vht_cap.vht_supported; > > - if (sband->ht_cap.ht_supported) > - local->rx_chains = > - max(ieee80211_mcs_to_chains(&sband- > >ht_cap.mcs), > - local->rx_chains); > + if (!sband->ht_cap.ht_supported) > + continue; > + > + local->rx_chains = > + max(ieee80211_mcs_to_chains(&sband- > >ht_cap.mcs), > + local->rx_chains); > + > + sband->ht_cap.cap |= WLAN_HT_CAP_SM_PS_DISABLED << > + IEEE80211_HT_CAP_SM_PS_SHIFT; This ... looks fishy. I know it's not, since it sets both bits, but still. Additionally, ath10k appears to be setting this to WLAN_HT_CAP_SM_PS_DYNAMIC already, so apparently it's expecting something to happen with that value? Is it really correct then to be overwriting it? johannes
