On 7-1-2017 21:36, Rafał Miłecki wrote: > From: Rafał Miłecki <rafal@xxxxxxxxxx> > > During bands setup we disable all channels that firmware doesn't support > in the current regulatory setup. If we do this before wiphy_register > it will result in copying set flags (including IEEE80211_CHAN_DISABLED) > to the orig_flags which is supposed to be persistent. We don't want this > as regulatory change may result in enabling some channels. We shouldn't > mess with orig_flags then (by changing them or ignoring them) so it's > better to just take care of their proper values. > > This patch cleanups code a bit (by taking orig_flags more seriously) and > allows further improvements like disabling really unavailable channels. > We will need that e.g. if some frequencies should be disabled for good > due to hardware setup (design). I think this and previous patch are too dependent and prefer to have them in a single patch. Despite that for both: Acked-by: Arend van Spriel <arend.vanspriel@xxxxxxxxxxxx> > Signed-off-by: Rafał Miłecki <rafal@xxxxxxxxxx> > --- > drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c | 9 +++++++-- > 1 file changed, 7 insertions(+), 2 deletions(-) > > diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c > index 45ee5b6..729bf33 100644 > --- a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c > +++ b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c > @@ -6477,8 +6477,7 @@ static int brcmf_setup_wiphy(struct wiphy *wiphy, struct brcmf_if *ifp) > wiphy->bands[NL80211_BAND_5GHZ] = band; > } > } > - err = brcmf_setup_wiphybands(wiphy); > - return err; > + return 0; > } > > static s32 brcmf_config_dongle(struct brcmf_cfg80211_info *cfg) > @@ -6843,6 +6842,12 @@ struct brcmf_cfg80211_info *brcmf_cfg80211_attach(struct brcmf_pub *drvr, > goto priv_out; > } > > + err = brcmf_setup_wiphybands(wiphy); > + if (err) { > + brcmf_err("Setting wiphy bands failed (%d)\n", err); > + goto wiphy_unreg_out; > + } > + > /* If cfg80211 didn't disable 40MHz HT CAP in wiphy_register(), > * setup 40MHz in 2GHz band and enable OBSS scanning. > */ >