What is with the patch numbering, ie. 3/2? On 3-1-2017 12:03, Rafał Miłecki wrote: > From: Rafał Miłecki <rafal@xxxxxxxxxx> > > There are some devices (e.g. Netgear R8000 home router) with one chipset > model used for different radios, some of them limited to subbands. NVRAM > entries don't contain any extra info on such limitations and firmware > reports full list of channels to us. We need to store extra limitation > info on DT to support such devices properly. > > This patch adds check for channel being disabled with orig_flags which > is how this wiphy helper works. this is the first mention about the wiphy helper. Probably need statement here that call to wiphy_read_of_freq_limits() was added in this patch which applies the extra limitation info read from DT. > Signed-off-by: Rafał Miłecki <rafal@xxxxxxxxxx> > --- > This patch should probably go through wireless-driver-next, I'm sending > it just as a proof of concept. It was succesfully tested on SmartRG > SR400ac with BCM43602. > > V4: Respect IEEE80211_CHAN_DISABLED in orig_flags > --- > drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c | 4 ++++ > 1 file changed, 4 insertions(+) > > diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c > index ccae3bb..f95e316 100644 > --- a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c > +++ b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c > @@ -5886,6 +5886,9 @@ static int brcmf_construct_chaninfo(struct brcmf_cfg80211_info *cfg, > band->band); > channel[index].hw_value = ch.control_ch_num; > > + if (channel->orig_flags & IEEE80211_CHAN_DISABLED) > + continue; > + > /* assuming the chanspecs order is HT20, > * HT40 upper, HT40 lower, and VHT80. > */ > @@ -6477,6 +6480,7 @@ static int brcmf_setup_wiphy(struct wiphy *wiphy, struct brcmf_if *ifp) > wiphy->bands[NL80211_BAND_5GHZ] = band; > } > } > + wiphy_read_of_freq_limits(wiphy); The return value is ignored, which I suppose is fine. So does the function need a return value at all? Is there a scenario where the DT info *must* be supplied? Regards, Arend
