From: Rafał Miłecki <rafal@xxxxxxxxxx> There are some devices (e.g. Netgear R8000 home router) with one chipset model used for different radios, some of them limited to subbands. NVRAM entries don't contain any extra info on such limitations and firmware reports full list of channels to us. We need to store extra limitation info on DT to support such devices properly. This patch adds check for channel being disabled with orig_flags which is how this wiphy helper works. Signed-off-by: Rafał Miłecki <rafal@xxxxxxxxxx> --- This patch should probably go through wireless-driver-next, I'm sending it just as a proof of concept. It was succesfully tested on SmartRG SR400ac with BCM43602. V4: Respect IEEE80211_CHAN_DISABLED in orig_flags --- drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c | 4 ++++ 1 file changed, 4 insertions(+) diff --git a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c index ccae3bb..f95e316 100644 --- a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c +++ b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/cfg80211.c @@ -5886,6 +5886,9 @@ static int brcmf_construct_chaninfo(struct brcmf_cfg80211_info *cfg, band->band); channel[index].hw_value = ch.control_ch_num; + if (channel->orig_flags & IEEE80211_CHAN_DISABLED) + continue; + /* assuming the chanspecs order is HT20, * HT40 upper, HT40 lower, and VHT80. */ @@ -6477,6 +6480,7 @@ static int brcmf_setup_wiphy(struct wiphy *wiphy, struct brcmf_if *ifp) wiphy->bands[NL80211_BAND_5GHZ] = band; } } + wiphy_read_of_freq_limits(wiphy); err = brcmf_setup_wiphybands(wiphy); return err; } -- 2.10.1
