Hi Pan, The problem fixed!! Thank you! - cantona On 17 July 2015 at 18:39, Su Kang Yin <paradyse@xxxxxxxxx> wrote: > Hi Pan, > > I applied 736-MIPS-ath79-fix-chained-irq-disable.patch but make no difference. > > Thanks, > cantona > > [ 238.200000] ath: phy3: rx chain 1: iq corr coeff=fffffffd > [ 238.210000] ath: phy3: Doing Tx IQ Cal for chain 1 > [ 238.210000] ath: phy3: IQ_RES[0]=0xcf4e200e IQ_RES[1]=0xff2f > [ 238.220000] ath: phy3: IQ_RES[2]=0xf3f314f4 IQ_RES[3]=0x292f > [ 238.220000] ath: phy3: IQ_RES[4]=0x9cfa7001 IQ_RES[5]=0xfe32 > [ 238.230000] ath: phy3: chain 1: mag mismatch=0 phase mismatch=0 > [ 238.230000] ath: phy3: tx chain 1: mag corr=1 phase corr=-13 > [ 238.240000] ath: phy3: tx chain 1: iq corr coeff=f3 > [ 238.250000] ath: phy3: rx chain 1: mag corr=-1 phase corr=-3 > [ 238.250000] ath: phy3: rx chain 1: iq corr coeff=fffffffd > [ 238.260000] ath: phy3: Doing Tx IQ Cal for chain 1 > [ 238.260000] ath: phy3: IQ_RES[0]=0xc654d011 IQ_RES[1]=0xff9f > [ 238.270000] ath: phy3: IQ_RES[2]=0xf0f20561 IQ_RES[3]=0x2caf > [ 238.270000] ath: phy3: IQ_RES[4]=0xd0f9dffd IQ_RES[5]=0xfe02 > [ 238.280000] ath: phy3: chain 1: mag mismatch=0 phase mismatch=0 > [ 238.280000] ath: phy3: tx chain 1: mag corr=0 phase corr=-13 > [ 238.290000] ath: phy3: tx chain 1: iq corr coeff=73 > [ 238.300000] ath: phy3: rx chain 1: mag corr=-1 phase corr=-2 > [ 238.300000] ath: phy3: rx chain 1: iq corr coeff=fffffffe > [ 238.310000] ath: phy3: enabling IQ Calibration > [ 238.310000] ath: phy3: starting IQ Mismatch Calibration > [ 238.320000] ath: phy3: Enabled BB Watchdog timeout (25 ms) > [ 238.320000] ath: phy3: New interrupt mask 0xf4000473 > [ 238.330000] ath: phy3: new IMR 0x81800175 > [ 238.330000] ath: phy3: macaddr: 00:1a:dd:d4:73:a0, bssid: > 00:00:00:00:00:00, bssidmask: ff:ff:ff:ff:ff:ff > [ 238.340000] ath: phy3: Enable MIB counters > [ 238.350000] ath: phy3: Restore history: opmode 2 chan 2412 Mhz > is_scanning=0 ofdm:3 cck:2 > [ 238.350000] ath: phy3: **** ofdmlevel 3=>3, rssi=0[lo=7 hi=40] > [ 238.360000] ath: phy3: **** ccklevel 2=>2, rssi=0[lo=7 hi=40] > [ 238.370000] ath: phy3: New interrupt mask 0xf4000473 > [ 238.370000] ath: phy3: new IMR 0x81800175 > [ 238.370000] ath: phy3: enable IER > Freezed here-------------------- > > On 17 July 2015 at 17:28, Pan, Miaoqing <miaoqing@xxxxxxxxxxxxxxxx> wrote: >> +Felix >> >> Seems the new version miss two patches, >> >> Upstream: a3e6c1eff54878506b2dddcc202df9cc8180facb >> http://git.openwrt.org/?p=openwrt.git;a=blob;f=target/linux/ar71xx/patches-3.18/736-MIPS-ath79-fix-chained-irq-disable.patch;h=8cb38d3971678e3cf951d36e6ab2f4b170cd1f0c;hb=HEAD >> >> - Miaoqing >> >> -----Original Message----- >> From: Su Kang Yin [mailto:paradyse@xxxxxxxxx] >> Sent: Friday, July 17, 2015 4:36 PM >> To: linux-wireless@xxxxxxxxxxxxxxx; ath9k-devel >> Subject: Re: ath9k 4.1.2 freeze >> >> log attached >> >> On 17 July 2015 at 16:35, Su Kang Yin <paradyse@xxxxxxxxx> wrote: >>> resend >>> >>> >>> On 17 July 2015 at 16:33, Su Kang Yin <paradyse@xxxxxxxxx> wrote: >>>> >>>> Hi, >>>> >>>> Kernel 4.1.2 ath9k with atheros DB120, driver lockup on "enable IER" >>>> after AHB interface up (PCI interface is fine). No problem found on kernel 3.10. >>>> >>>> - cantona >>>> >>>> [ 83.990000] ath: phy1: tx chain 1: iq corr coeff=74 >>>> [ 84.000000] ath: phy1: rx chain 1: mag corr=0 phase corr=-2 >>>> [ 84.000000] ath: phy1: rx chain 1: iq corr coeff=7e >>>> [ 84.010000] ath: phy1: Doing Tx IQ Cal for chain 1 >>>> [ 84.010000] ath: phy1: IQ_RES[0]=0xd248900b IQ_RES[1]=0xfeff >>>> [ 84.020000] ath: phy1: IQ_RES[2]=0xf0f46499 IQ_RES[3]=0x262f >>>> [ 84.020000] ath: phy1: IQ_RES[4]=0x66fa9fff IQ_RES[5]=0xfe82 >>>> [ 84.030000] ath: phy1: chain 1: mag mismatch=0 phase mismatch=0 >>>> [ 84.040000] ath: phy1: tx chain 1: mag corr=0 phase corr=-13 >>>> [ 84.040000] ath: phy1: tx chain 1: iq corr coeff=73 >>>> [ 84.050000] ath: phy1: rx chain 1: mag corr=0 phase corr=-3 >>>> [ 84.050000] ath: phy1: rx chain 1: iq corr coeff=7d >>>> [ 84.060000] ath: phy1: Doing Tx IQ Cal for chain 1 >>>> [ 84.060000] ath: phy1: IQ_RES[0]=0xcc4ed011 IQ_RES[1]=0xff2f >>>> [ 84.070000] ath: phy1: IQ_RES[2]=0xeff334fa IQ_RES[3]=0x295f >>>> [ 84.070000] ath: phy1: IQ_RES[4]=0x9bfa1ffd IQ_RES[5]=0xfe42 >>>> [ 84.080000] ath: phy1: chain 1: mag mismatch=0 phase mismatch=0 >>>> [ 84.090000] ath: phy1: tx chain 1: mag corr=0 phase corr=-14 >>>> [ 84.090000] ath: phy1: tx chain 1: iq corr coeff=72 >>>> [ 84.100000] ath: phy1: rx chain 1: mag corr=0 phase corr=-2 >>>> [ 84.100000] ath: phy1: rx chain 1: iq corr coeff=7e >>>> [ 84.110000] ath: phy1: enabling IQ Calibration >>>> [ 84.110000] ath: phy1: starting IQ Mismatch Calibration >>>> [ 84.120000] ath: phy1: Enabled BB Watchdog timeout (25 ms) >>>> [ 84.120000] ath: phy1: New interrupt mask 0xf4000473 >>>> [ 84.130000] ath: phy1: new IMR 0x81800175 >>>> [ 84.130000] ath: phy1: macaddr: 00:11:aa:d4:73:a0, bssid: >>>> 00:00:00:00:00:00, bssidmask: ff:ff:ff:ff:ff:ff >>>> [ 84.140000] ath: phy1: Enable MIB counters >>>> [ 84.150000] ath: phy1: Restore history: opmode 2 chan 2412 Mhz >>>> is_scanning=0 ofdm:3 cck:2 >>>> [ 84.150000] ath: phy1: **** ofdmlevel 3=>3, rssi=0[lo=7 hi=40] >>>> [ 84.160000] ath: phy1: **** ccklevel 2=>2, rssi=0[lo=7 hi=40] >>>> [ 84.170000] ath: phy1: New interrupt mask 0xf4000473 >>>> [ 84.170000] ath: phy1: new IMR 0x81800175 >>>> [ 84.170000] ath: phy1: enable IER >>>> =======================<FREEZE on wlan1 >>>> (AHB))======================================== >>>> -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
