Michal Kazior <michal.kazior@xxxxxxxxx> writes: > Until now only a single fixed tx rate or nss was > allowed to be set. > > The patch attempts to improve this by allowing > most bitrate masks. The limitation is VHT MCS > rates cannot be expressed separately using > existing firmware interfaces and only the > following VHT MCS ranges are supported: none, 0-7, > 0-8, and 0-9. > > This keeps the old behaviour when requesting > single tx rate or single nss. The new bitrate mask > logic is only applied to other cases that would > return -EINVAL until now. > > Depending on firmware revisions some combinations > may crash firmware so use with care, please. > > This depends on "ath10k: don't use reassoc flag". > Without it key cache would effectively be > invalidated upon bitrate change leading to > communication being no longer possible. > > Signed-off-by: Michal Kazior <michal.kazior@xxxxxxxxx> Thanks, applied. -- Kalle Valo -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
