> On Wednesday 16 July 2014 08:24:58 Michal Kazior wrote:
> > > * So far, we always get 64 bins of fft data in the samples, even if we
> > >
> > > are in HT40 or VHT80 mode. That doesn't seem right, as there should
> > > be more bins for wider channels (e.g. 128 or 256 bins). Is there any
> > > parameter to change in the configuration to get the output from
> > > multiple channels / higher bandwidth?
> >
> > Hmm.. I suspect this may be because you use scan command. Scanning
> > uses channel list which is programmed with legacy modes a and g
> > (implying 20Mhz). Perhaps that's the limiting factor now. Using other
> > (wider) modes breaks scan from what I remember but it might be worth
> > checking out if it impacts fft bin sizes.
>
> I did the HT80 and HT40 stuff on a single channel in the spectral
> "background" mode. They reports from the firmware (10.1) still only had 64
> bins. The HT80 stuff wasn't tested with the "main" firmware because it
> refused to switch to HT80 mode as AP/Sta.
Just to clarify this a little more, we tried AP (running hostapd) as well a
STA in 40 and 80 MHz modes. We always got 64 bins returned.
Cheers,
Simon
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
