On Wed, 2013-07-10 at 18:48 +0100, José Miguel Gonçalves wrote: > On 10-07-2013 18:17, Luciano Coelho wrote: > > On Wed, 2013-07-10 at 17:30 +0100, José Miguel Gonçalves wrote: > >> On 10-07-2013 13:34, José Miguel Gonçalves wrote: > >>> I will try a new AP to see how it behaves... > >>> > >> I've tested with my Android smartphone acting as an AP, without authentication, > >> and I'm also unable to associate! > >> > >> I get from iw the following error message: > >> > >> wlan0 (phy #0): failed to connect to b4:07:f9:49:cc:65, status: 1: Unspecified failure > >> > >> Complete log is here: > >> > >> http://pastebin.com/DzPmMw8i > >> > >> So, something is definitely wrong with my setup... but what? > >> Hope that log has some useful info for you... > > This definitely looks like RF problems. Especially this: > > > > [ 177.575000] wlan0: send auth to b4:07:f9:49:cc:65 (try 1/3) > > [ 177.595000] wlan0: send auth to b4:07:f9:49:cc:65 (try 2/3) > > [ 177.605000] wlcore: EVENT on mbox 1 > > [ 177.605000] wlcore: MBOX vector: 0x100000 > > [ 177.610000] wlcore: MAX_TX_FAILURE_EVENT_ID > > [ 177.615000] wlan0: send auth to b4:07:f9:49:cc:65 (try 3/3) > > [ 177.640000] wlan0: authentication with b4:07:f9:49:cc:65 timed out > > > > You are send auth requests out, but not getting anything back. > > Apparently you're not even getting ACKs (as pointed out by the > > MAX_TX_FAILURE_EVENT_ID). > > Hum. I never considered RF problems because I'm testing this module with a > Jorjin's development kit, so I was considering that Jorjin knows how to make PCBs > for RF. Also seeing that when I remove the antenna the AP signal strength changes > from -51 dBm to -73 dBm was a signal to me that the RF was OK. > > > > > Do you have a sniffer? You could try to use your TP-Link dongle with > > wireshark to see if it works fine as a sniffer. > > I have a text console only system. I could put tcpdump on my system, but I think I > can not monitor wireless traffic with it, or can I? tcpdump will probably not be enough. But since this stuff is *wireless* you can sniff from a different PC. If you have Linux PC, just plug in your TP-Link dongle in it, launch wireshark and you should be able to sniff (unencrypted) connections between other devices easily. You can also sniff encrypted connections, but it's slightly more difficult. Also, I've had problems when sniffing 802.11n (more specifically BA sessions), but you're not getting that far, so it should be possible to see some good results with simple sniffers. -- Luca. -- To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
