From: Ido Reis <idor@xxxxxx>
In PG2.0 there is an issue where PHY's FDSP Code RAM sometimes gets
corrupted when exiting from ELP mode. This issue is related to FDSP
Code RAM clock implementation.
PG2.1 introduces a HW fix for this issue that requires the driver to
change the FDSP Code Ram clock settings (mux it to ATGP clock instead
of its own clock).
This workaround uses PHY_FPGA_SPARE_1 register and is relevant to WL8
PG2.1 devices.
The fix is also backward compatible with older PG2.0 devices where the
register PHY_FPGA_SPARE_1 is not used and not connected.
The fix is done in the wl18xx_pre_upload function (must be performed
before uploading the FW code) and includes the following steps:
1. Disable FDSP clock
2. Set ATPG clock toward FDSP Code RAM rather than its own clock.
3. Re-enable FDSP clock
Signed-off-by: Yair Shapira <yair.shapira@xxxxxx>
Signed-off-by: Ido Reis <idor@xxxxxx>
Signed-off-by: Arik Nemtsov <arik@xxxxxxxxxx>
Signed-off-by: Luciano Coelho <coelho@xxxxxx>
---
This replaces a patch that was part of a series that Arik sent a while
ago. Just did some clean-ups and tested with PG2.1.
drivers/net/wireless/ti/wl18xx/main.c | 36 +++++++++++++++++++++++++++++++--
drivers/net/wireless/ti/wl18xx/reg.h | 15 ++++++++++++++
2 files changed, 49 insertions(+), 2 deletions(-)
diff --git a/drivers/net/wireless/ti/wl18xx/main.c b/drivers/net/wireless/ti/wl18xx/main.c
index 9fa692d..ae85ae4 100644
--- a/drivers/net/wireless/ti/wl18xx/main.c
+++ b/drivers/net/wireless/ti/wl18xx/main.c
@@ -594,8 +594,8 @@ static const struct wlcore_partition_set wl18xx_ptable[PART_TABLE_LEN] = {
.mem3 = { .start = 0x00000000, .size = 0x00000000 },
},
[PART_PHY_INIT] = {
- .mem = { .start = 0x80926000,
- .size = sizeof(struct wl18xx_mac_and_phy_params) },
+ .mem = { .start = WL18XX_PHY_INIT_MEM_ADDR,
+ .size = WL18XX_PHY_INIT_MEM_SIZE },
.reg = { .start = 0x00000000, .size = 0x00000000 },
.mem2 = { .start = 0x00000000, .size = 0x00000000 },
.mem3 = { .start = 0x00000000, .size = 0x00000000 },
@@ -799,6 +799,9 @@ static int wl18xx_pre_upload(struct wl1271 *wl)
u32 tmp;
int ret;
+ BUILD_BUG_ON(sizeof(struct wl18xx_mac_and_phy_params) >
+ WL18XX_PHY_INIT_MEM_SIZE);
+
ret = wlcore_set_partition(wl, &wl->ptable[PART_BOOT]);
if (ret < 0)
goto out;
@@ -815,6 +818,35 @@ static int wl18xx_pre_upload(struct wl1271 *wl)
wl1271_debug(DEBUG_BOOT, "chip id 0x%x", tmp);
ret = wlcore_read32(wl, WL18XX_SCR_PAD2, &tmp);
+ if (ret < 0)
+ goto out;
+
+ /*
+ * Workaround for FDSP code RAM corruption (needed for PG2.1
+ * and newer; for older chips it's a NOP). Change FDSP clock
+ * settings so that it's muxed to the ATGP clock instead of
+ * its own clock.
+ */
+
+ ret = wlcore_set_partition(wl, &wl->ptable[PART_PHY_INIT]);
+ if (ret < 0)
+ goto out;
+
+ /* disable FDSP clock */
+ ret = wlcore_write32(wl, WL18XX_PHY_FPGA_SPARE_1,
+ MEM_FDSP_CLK_120_DISABLE);
+ if (ret < 0)
+ goto out;
+
+ /* set ATPG clock toward FDSP Code RAM rather than its own clock */
+ ret = wlcore_write32(wl, WL18XX_PHY_FPGA_SPARE_1,
+ MEM_FDSP_CODERAM_FUNC_CLK_SEL);
+ if (ret < 0)
+ goto out;
+
+ /* re-enable FDSP clock */
+ ret = wlcore_write32(wl, WL18XX_PHY_FPGA_SPARE_1,
+ MEM_FDSP_CLK_120_ENABLE);
out:
return ret;
diff --git a/drivers/net/wireless/ti/wl18xx/reg.h b/drivers/net/wireless/ti/wl18xx/reg.h
index 6306e04..05dd8ba 100644
--- a/drivers/net/wireless/ti/wl18xx/reg.h
+++ b/drivers/net/wireless/ti/wl18xx/reg.h
@@ -38,6 +38,9 @@
#define WL18XX_REG_BOOT_PART_SIZE 0x00014578
#define WL18XX_PHY_INIT_MEM_ADDR 0x80926000
+#define WL18XX_PHY_END_MEM_ADDR 0x8093CA44
+#define WL18XX_PHY_INIT_MEM_SIZE \
+ (WL18XX_PHY_END_MEM_ADDR - WL18XX_PHY_INIT_MEM_ADDR)
#define WL18XX_SDIO_WSPI_BASE (WL18XX_REGISTERS_BASE)
#define WL18XX_REG_CONFIG_BASE (WL18XX_REGISTERS_BASE + 0x02000)
@@ -217,4 +220,16 @@ static const char * const rdl_names[] = {
[RDL_4_SP] = "1897 MIMO",
};
+/* FPGA_SPARE_1 register - used to change the PHY ATPG clock at boot time */
+#define WL18XX_PHY_FPGA_SPARE_1 0x8093CA40
+
+/* command to disable FDSP clock */
+#define MEM_FDSP_CLK_120_DISABLE 0x80000000
+
+/* command to set ATPG clock toward FDSP Code RAM rather than its own clock */
+#define MEM_FDSP_CODERAM_FUNC_CLK_SEL 0xC0000000
+
+/* command to re-enable FDSP clock */
+#define MEM_FDSP_CLK_120_ENABLE 0x40000000
+
#endif /* __REG_H__ */
--
1.7.10.4
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
