On Sun, Mar 17, 2013 at 10:46:27PM +0100, Felix Fietkau wrote:
> On 2013-03-17 10:23 PM, Karl Beldan wrote:
> > On Fri, Mar 15, 2013 at 04:36:58PM +0100, Johannes Berg wrote:
> >> On Tue, 2013-03-12 at 10:41 +0100, Karl Beldan wrote:
> >> > On Wed, Feb 13, 2013 at 10:51:08AM +0100, Felix Fietkau wrote:
> >> > > When MCS rates start to get bad in 2.4 GHz because of long range or
> >> > > strong interference, CCK rates can be a lot more robust.
> >> > >
> >> > > This patch adds a pseudo MCS group containing CCK rates (long preamble
> >> > > in the lower 4 slots, short preamble in the upper slots).
> >> > >
> >> > With this, mac80211 might send CCK rates with IEEE80211_TX_CTL_AMPDU set.
> >> > For aggregates, if we don't currently set NO_CCK, at the very least the
> >> > 1st rate index should belong to an MCS_GROUP.
> >>
> >> I guess that depends on how you expect rate control to work ... I'd
> >> kinda expect the driver to skip aggregation then? I think only ath9k
> >> even uses minstrel + aggregation?
> >>
> >
> > This changes the meaning of IEEE80211_TX_CTL_AMPDU.
> > With this there are more possible RC feedback pitfalls with the tx statuses
> > IEEE80211_TX_{CTL,STAT}_AMPDU flags.
> > Regarding the drivers using minstrel + aggregation I can't really say, I
> > know ath9k runs ok with it and at work I settled for minstrel too with a
> > driver for our IP on a demo board.
> It's important that the IEEE80211_TX_CTL_AMPDU flag is still set,
> because the frame is still part of the BlockAck window, just sent with a
> rate that doesn't allow aggregating it with other frames, so it is still
> part of the A-MPDU session.
The best way I could look at it was that it would let drivers know the frame is
being transmitted under BA, but it still changes the meaning and thus
the handling of the flag.
Frankly, if the meaning "officially" becomes "this frames is being
transmitted under BA", as the code behaves, and you seem to say, I am all
for it ;)
Karl
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
