also perform full noise calibration in ath5k_hw_rf511x_calibrate() instead of
just writing the bit.
Changes-licensed-under: ISC
Signed-off-by: Bruno Randolf <bruno@xxxxxxxxxxxxx>
---
drivers/net/wireless/ath5k/phy.c | 3 +--
1 files changed, 1 insertions(+), 2 deletions(-)
diff --git a/drivers/net/wireless/ath5k/phy.c b/drivers/net/wireless/ath5k/phy.c
index 9b91121..f250c2e 100644
--- a/drivers/net/wireless/ath5k/phy.c
+++ b/drivers/net/wireless/ath5k/phy.c
@@ -1702,8 +1702,7 @@ static int ath5k_hw_rf511x_calibrate(struct ath5k_hw *ah,
((u32)q_coff) | ((u32)i_coff << AR5K_PHY_IQ_CORR_Q_I_COFF_S));
done:
- /* Start noise floor calibration */
- AR5K_REG_ENABLE_BITS(ah, AR5K_PHY_AGCCTL, AR5K_PHY_AGCCTL_NF);
+ ath5k_hw_noise_floor_calibration(ah, channel->freq);
/* Request RF gain */
if (channel->val & CHANNEL_5GHZ) {
--
1.5.3.4
-
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
