On Sat, 2012-01-14 at 12:06 -0600, Ted Salmon wrote: > > My config.xml has an entry for: > > 6000 > I believe this value is miliseconds so I set it to 86400000 > > Maybe that is what you are looking for? > > > > I believe you can also create /etc/modprobe.d/i2400m.conf containing: > > options i2400m idle_mode_disabled=1 > > to disable idle mode entirely... > I tried this as well, unfortunately the driver randomly ignored this setting. > Either way the issue was resolved by setting an impossibly high idle timeout. Thanks :).A word to all Clear(wire)/Other MVNO users - If you maintain your realm as welcome.clearwire-wmx.net, etc you will NOT receive proper SLA assignments (you will be limited to 5.5 mbps down and 512kbps up) - remove the 'welcome' prefix from all realms in the WiMAX_DB.bin file. > Now, onto trying to figure out how to get my cards TX Power above .5 milliwatts and sorting through the daemon's source! Note that if you don't remove the "welcome." part you may never get past the VLAN landing page too; you'll be in a loop where it always says "we have an important message for you" and you can't ever get to the actual internet. Dan
