在 2021/6/29 上午11:56, Yongji Xie 写道:
On Tue, Jun 29, 2021 at 11:29 AM Jason Wang <jasowang@xxxxxxxxxx> wrote:
在 2021/6/29 上午10:26, Yongji Xie 写道:
On Mon, Jun 28, 2021 at 12:40 PM Jason Wang <jasowang@xxxxxxxxxx> wrote:
在 2021/6/25 下午12:19, Yongji Xie 写道:
2b) for set_status(): simply relay the message to userspace, reply is no
needed. Userspace will use a command to update the status when the
datapath is stop. The the status could be fetched via get_stats().
2b looks more spec complaint.
Looks good to me. And I think we can use the reply of the message to
update the status instead of introducing a new command.
Just notice this part in virtio_finalize_features():
virtio_add_status(dev, VIRTIO_CONFIG_S_FEATURES_OK);
status = dev->config->get_status(dev);
if (!(status & VIRTIO_CONFIG_S_FEATURES_OK)) {
So we no reply doesn't work for FEATURES_OK.
So my understanding is:
1) We must not use noreply for set_status()
2) We can use noreply for get_status(), but it requires a new ioctl to
update the status.
So it looks to me we need synchronize for both get_status() and
set_status().
We should not send messages to userspace in the FEATURES_OK case. So
the synchronization is not necessary.
As discussed previously, there could be a device that mandates some
features (VIRTIO_F_RING_PACKED). So it can choose to not accept
FEATURES_OK is packed virtqueue is not negotiated.
In this case we need to relay the message to userspace.
OK, I see. If so, I prefer to only use noreply for set_status(). We do
not set the status bit if the message is failed. In this way, we don't
need to change lots of virtio core codes to handle the failure of
set_status()/get_status().
It should work.
Thanks
Thanks,
Yongji
_______________________________________________
Virtualization mailing list
Virtualization@xxxxxxxxxxxxxxxxxxxxxxxxxx
https://lists.linuxfoundation.org/mailman/listinfo/virtualization
