On Wed, May 01, 2013 at 08:40:54PM -0700, Tom Lyon wrote: > Virtiio_mmio attempts to mimic the layout of some control registers > from virtio_pci. These registers, in particular > VIRTIO_MMIO_QUEUE_SEL and VIRTIO_PCI_QUEUE_SEL, > are active in nature, and not just passive like a normal memory > location. Thus, the host side must react immediately upon write of > these registers to map some other registers (queue address, size, > etc) to queue-specific locations. This is just not possible for > mmio, and, I would argue, not desirable for PCI either. > > Because the queue selector register doesn't work in mmio, it is > clear that only single queue virtio devices can work. This means no > virtio_net - I've seen a few messages > complaining that it doesn't work but nothing so far on why. > > It seems from some messages back in March that there is a register > re-layout in the works for virtio_pci. I think that virtio_pci > could become just one of the > various ways to configure a virtio_mmio device and there would no > need for any "registers", just memory locations acting like memory. > The one gotcha is in > figuring out the kick/notify mechanism for the guest to notify the > host when there is work on a queue. For notify, using a hypervisor > call could unify the pci and mmio > cases, but comes with the cost of leaving the pure pci domain. > > I got into this code because I am looking at the possibility of > using an off the shelf embedded processor sitting on a PCIe port to > emulate the virtio pci interface. The > notion of active registers makes this a non-starter, whereas if > there was a purely memory based system like mmio (with mq fixes), a > real PCI device could easily emulate it. > Excepting, of course, whatever the notify mechanism is. If it were > hypercall based, then the hypervisor could call a transport or > device specific way of notifying and a small > notify driver could poke the PCI device is some way. This was discussed on this thread: '[PATCH 16/22] virtio_pci: use separate notification offsets for each vq' Please take a look there and confirm that this addresses your concern. I'm working on making memory io as fast as pio on x86, implemented on intel, once I do it on AMD too and assuming it's as fast as PIO, we'll do mmio everywhere. Then with a PCI card, you won't have exits for notification just normal passthrough. -- MST _______________________________________________ Virtualization mailing list Virtualization@xxxxxxxxxxxxxxxxxxxxxxxxxx https://lists.linuxfoundation.org/mailman/listinfo/virtualization
