On Sat, Nov 30, 2013 at 02:38:29PM +0100, Marc Kleine-Budde wrote: > On 11/22/2013 09:14 AM, Peter Chen wrote: > > If we connect Male-A-To-Male-A cable between otg-host and host pc, > > the ci->vbus_active is set wrongly, and cause the controller run > > at peripheral mode when we load gadget module (ci_udc_start will be run), > > but the software runs at host mode due to id = 0. The ehci_irq > > can't handle suspend (USBi_SLI) interrupt which is enabled for > > peripheral mode, it causes no one will handle irq error. > > > > Cc: stable@xxxxxxxxxxxxxxx # 3.12 > > Acked-by: Michael Grzeschik <mgr@xxxxxxxxxxxxxx> > > Reported-by: Marc Kleine-Budde <mkl@xxxxxxxxxxxxxx> > > Tested-by: Marc Kleine-Budde <mkl@xxxxxxxxxxxxxx> > > Signed-off-by: Marc Kleine-Budde <mkl@xxxxxxxxxxxxxx> > > Signed-off-by: Peter Chen <peter.chen@xxxxxxxxxxxxx> > Applied, Thanks. -- Best Regards, Peter Chen -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
