Hi Peter, > > Hi Peter, > > > > > > Peter, I dunno if you are already aware of it, but the USB peripheral > > > > mode hangs > > > > on MX233. It's easy to replicate for example if you try to run CDC > > > > ethernet over > > > > the USB peripheral mode, then telnet into the board and run "dmesg" . > > > > This will > > > > trigger a "larger" data transfer which will make the UDC driver hang. > > > > This > > > > doesn't happen on MX28 so it must be some MX233-specific thing. > > > > > > Marek, Have you tried below? > > > > > > http://marc.info/?l=linux-usb&m=136537318510847&w=2 > > > > > > It may not the USB itself problem, the mx23's usb is almost > > > the same with mx28's. > > > > This also happens on a different MX23-based board for me. This other > > board I > > tried has mDDR DRAM and the DRAM is operating correctly. The 96MHz thing > > people > > complained about in the Olimex forum is resolved now. > > Add shawn. > > Marek, have you tried mx23 evk? Ok, I just tried the MX23EVK. Running "dmesg" via telnet connection resulted in a hang of the USB driver (likely), but since I have serial connection to the board, I was able to verify the board itself didn't crash. I can still operate the board via serial console, it's only the USB in peripheral mode ethernet that is hung. > Shawn, marek reported the udc function at mx23 works abnormal, but it works > good at mx28. Have you tried mx23 udc recently? > > Best regards, > Peter Best regards, Marek Vasut -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html