On Thu, Dec 27, 2012 at 08:21:55AM +0100, Marek Vasut wrote: > Dear Peter Chen, > > [...] > > + > > +#define CI_VBUS_STABLE_TIMEOUT 500 > > Shall we not change this to static const int instead ? Is it a must? I find the similar at drivers/usb/core/hub.c 2433 #define PORT_RESET_TRIES 5 2434 #define SET_ADDRESS_TRIES 2 2435 #define GET_DESCRIPTOR_TRIES 2 2436 #define SET_CONFIG_TRIES (2 * (use_both_schemes + 1)) 2437 #define USE_NEW_SCHEME(i) ((i) / 2 == (int)old_scheme_first) 2438 2439 #define HUB_ROOT_RESET_TIME 50 /* times are in msec */ 2440 #define HUB_SHORT_RESET_TIME 10 2441 #define HUB_BH_RESET_TIME 50 2442 #define HUB_LONG_RESET_TIME 200 2443 #define HUB_RESET_TIMEOUT 500 > > [...] > > > --- a/drivers/usb/chipidea/udc.c > > +++ b/drivers/usb/chipidea/udc.c > > @@ -1371,6 +1371,7 @@ static int ci13xxx_vbus_session(struct usb_gadget > > *_gadget, int is_active) pm_runtime_get_sync(&_gadget->dev); > > hw_device_reset(ci, USBMODE_CM_DC); > > hw_device_state(ci, ci->ep0out->qh.dma); > > + dev_dbg(ci->dev, "Connected to host\n"); > > } else { > > hw_device_state(ci, 0); > > if (ci->platdata->notify_event) > > @@ -1378,6 +1379,7 @@ static int ci13xxx_vbus_session(struct usb_gadget > > *_gadget, int is_active) CI13XXX_CONTROLLER_STOPPED_EVENT); > > _gadget_stop_activity(&ci->gadget); > > pm_runtime_put_sync(&_gadget->dev); > > + dev_dbg(ci->dev, "disconnected from host\n"); > > Keep the capital letters at the begining of the sentence consistent -- either > start with capital D here or fix the capital C above. Thanks, I will change "d" to "D". > > > } > > } > -- Best Regards, Peter Chen -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html