Bjorn Mork <bjorn@xxxxxxx> writes: > patch 3 adds the new driver. Most of it is QMI protocol handling. > The network device is a minimalistic usbnet minidriver. In case anyone wonders what this really does, here's an excerpt of a connection being initiated by simply doing "dhclient wwan1". "ip link set dev wwan1 up" would achieve the same, except for address configuration of course. I'm explaining inline: Dec 13 04:15:38 nemi kernel: [23893.115819] qmi_wwan 2-2:1.3: wwan1: register 'qmi_wwan' at usb-0000:00:1d.7-2, QMI speaking CDC ECM like wwan device, 76:bb:09:ca:8e:84 Dec 13 04:15:38 nemi kernel: [23893.116732] usbcore: registered new interface driver qmi_wwan Dec 13 04:15:40 nemi kernel: [23894.842205] usb 2-2: QMI_CTL request: msg 0x0022 (len 15) from "control point" with cid=0x00 and TLVs: Dec 13 04:15:40 nemi kernel: [23894.842214] usb 2-2: [0x01] (1) 01 . requesting a client ID for subsystem QMI_WDS. We need this for starting the network connection. Dec 13 04:15:40 nemi kernel: [23894.944602] usb 2-2: QMI_CTL response: msg 0x0022 (len 23) from "service" with cid=0x00 and TLVs: Dec 13 04:15:40 nemi kernel: [23894.944614] usb 2-2: [0x02] (4) SUCCESS (0x0000) Dec 13 04:15:40 nemi kernel: [23894.944622] usb 2-2: [0x01] (2) 01 03 .. received QMI_WDS client ID = 3 Dec 13 04:15:40 nemi kernel: [23894.945827] usb 2-2: QMI_CTL request: msg 0x0022 (len 15) from "control point" with cid=0x00 and TLVs: Dec 13 04:15:40 nemi kernel: [23894.945837] usb 2-2: [0x01] (1) 02 . requesting a client ID for subsystem QMI_DMS. We need this for verifying SIM PIN state (well, we don't really need to do that, but it enables us to understand why the connection fails if a PIN code is required). Dec 13 04:15:40 nemi kernel: [23895.048729] usb 2-2: QMI_CTL response: msg 0x0022 (len 23) from "service" with cid=0x00 and TLVs: Dec 13 04:15:40 nemi kernel: [23895.048738] usb 2-2: [0x02] (4) SUCCESS (0x0000) Dec 13 04:15:40 nemi kernel: [23895.048743] usb 2-2: [0x01] (2) 02 03 .. received QMI_DMS client ID = 3 Dec 13 04:15:40 nemi kernel: [23895.050066] usb 2-2: QMI_DMS request: msg 0x002b (len 12) from "control point" with cid=0x03 and TLVs: requesting PIN code state Dec 13 04:15:40 nemi kernel: [23895.152746] usb 2-2: QMI_DMS response: msg 0x002b (len 31) from "service" with cid=0x03 and TLVs: Dec 13 04:15:40 nemi kernel: [23895.152758] usb 2-2: [0x02] (4) SUCCESS (0x0000) Dec 13 04:15:40 nemi kernel: [23895.152767] usb 2-2: [0x12] (3) PIN2 status=1, 3 verify retries left, 10 unblock retries left Dec 13 04:15:40 nemi kernel: [23895.152777] usb 2-2: [0x11] (3) PIN1 status=2, 3 verify retries left, 10 unblock retries left PIN1 is enabled but already verified, so we're ready to go. Dec 13 04:15:40 nemi kernel: [23895.153987] usb 2-2: QMI_WDS request: msg 0x0022 (len 12) from "control point" with cid=0x03 and TLVs: requesting connection state Dec 13 04:15:41 nemi kernel: [23895.256746] usb 2-2: QMI_WDS response: msg 0x0022 (len 23) from "service" with cid=0x03 and TLVs: Dec 13 04:15:41 nemi kernel: [23895.256757] usb 2-2: [0x02] (4) SUCCESS (0x0000) Dec 13 04:15:41 nemi kernel: [23895.256765] usb 2-2: [0x01] (1) 01 . state is disconnected Dec 13 04:15:41 nemi kernel: [23895.257967] usb 2-2: QMI_WDS request: msg 0x0020 (len 12) from "control point" with cid=0x03 and TLVs: starting a new connection Dec 13 04:15:41 nemi kernel: [23895.360622] usb 2-2: QMI_WDS response: msg 0x0020 (len 26) from "service" with cid=0x03 and TLVs: Dec 13 04:15:41 nemi kernel: [23895.360634] usb 2-2: [0x02] (4) SUCCESS (0x0000) Dec 13 04:15:41 nemi kernel: [23895.360641] usb 2-2: [0x01] (4) e8 90 15 02 .... successfully connected. Got a 32bit handle (needed for disconnect). The connection is now fully usable, and DHCP will now succeed (not shown). Dec 13 04:15:41 nemi kernel: [23895.361114] usb 2-2: QMI_WDS indication: msg 0x0022 (len 21) from "service" with cid=0xff (broadcast) and TLVs: Dec 13 04:15:41 nemi kernel: [23895.361124] usb 2-2: [0x01] (2) 02 00 .. Dec 13 04:15:41 nemi kernel: [23895.361131] usb 2-2: [0x12] (1) 04 . received an unsolicited QMI_WDS status message (sent to all clients) with the new IPv4 connected state Dec 13 04:15:41 nemi kernel: [23895.362343] usb 2-2: QMI_WDS request: msg 0x0001 (len 20) from "control point" with cid=0x03 and TLVs: Dec 13 04:15:41 nemi kernel: [23895.362352] usb 2-2: [0x10] (1) 01 . Dec 13 04:15:41 nemi kernel: [23895.362360] usb 2-2: [0x15] (1) 01 . request speed and system change updates. Nice to know, but not strictly required. Dec 13 04:15:41 nemi kernel: [23895.464623] usb 2-2: QMI_WDS response: msg 0x0001 (len 19) from "service" with cid=0x03 and TLVs: Dec 13 04:15:41 nemi kernel: [23895.464635] usb 2-2: [0x02] (4) SUCCESS (0x0000) received ack to the last request. That's the last we'll see until something changes. Bjørn -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
