MAX4967 USB power supply chip we use on our boards signals over-current when
power is not enabled; once it's enabled, over-current signal returns to normal.
That unfortunately caused the endless stream of "over-current change on port"
messages. The EHCI root hub code reacts on every over-current signal change
with powering off the port -- such change event is generated the moment the
port power is enabled, so once enabled the power is immediately cut off.
I think we should only cut off power when we're seeing the active over-current
signal, so I'm adding such check to that code. I also think that the fact that
we've cut off the port power should be reflected in the result of GetPortStatus
request immediately, hence I'm adding a PORTSCn register readback after write...
Signed-off-by: Sergei Shtylyov <sshtylyov@xxxxxxxxxxxxx>
Cc: stable@xxxxxxxxxx
---
The patch is against the 'usb-linus' branch of Greg KH's usb-2.6.git...
drivers/usb/host/ehci-hub.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
Index: usb-2.6/drivers/usb/host/ehci-hub.c
===================================================================
--- usb-2.6.orig/drivers/usb/host/ehci-hub.c
+++ usb-2.6/drivers/usb/host/ehci-hub.c
@@ -891,10 +891,11 @@ static int ehci_hub_control (
* power switching; they're allowed to just limit the
* current. khubd will turn the power back on.
*/
- if (HCS_PPC (ehci->hcs_params)){
+ if ((temp & PORT_OC) && HCS_PPC(ehci->hcs_params)) {
ehci_writel(ehci,
temp & ~(PORT_RWC_BITS | PORT_POWER),
status_reg);
+ temp = ehci_readl(ehci, status_reg);
}
}
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
