The commit
7e6502d577106fb5b202bbaac64c5f1b065 'mfd: Add omap-usbhs runtime PM support'
besides moving to RPM, removes necessary TLL initialization as well.
Restore the TLL initialization, without which device detection fails.
Signed-off-by: Jassi Brar <jaswinder.singh@xxxxxxxxxx>
---
drivers/mfd/omap-usb-host.c | 42 ++++++++++++++++++++++++++++++++++++++++++
1 files changed, 42 insertions(+), 0 deletions(-)
diff --git a/drivers/mfd/omap-usb-host.c b/drivers/mfd/omap-usb-host.c
index 8552195..12ca77b 100644
--- a/drivers/mfd/omap-usb-host.c
+++ b/drivers/mfd/omap-usb-host.c
@@ -640,6 +640,7 @@ static int usbhs_enable(struct device *dev)
struct usbhs_omap_platform_data *pdata = &omap->platdata;
unsigned long flags = 0;
int ret = 0;
+ unsigned long timeout;
unsigned reg;
dev_dbg(dev, "starting TI HSUSB Controller\n");
@@ -676,6 +677,47 @@ static int usbhs_enable(struct device *dev)
omap->usbhs_rev = usbhs_read(omap->uhh_base, OMAP_UHH_REVISION);
dev_dbg(dev, "OMAP UHH_REVISION 0x%x\n", omap->usbhs_rev);
+ /* perform TLL soft reset, and wait until reset is complete */
+ usbhs_write(omap->tll_base, OMAP_USBTLL_SYSCONFIG,
+ OMAP_USBTLL_SYSCONFIG_SOFTRESET);
+
+ /* Wait for TLL reset to complete */
+ timeout = jiffies + msecs_to_jiffies(1000);
+ while (!(usbhs_read(omap->tll_base, OMAP_USBTLL_SYSSTATUS)
+ & OMAP_USBTLL_SYSSTATUS_RESETDONE)) {
+ cpu_relax();
+
+ if (time_after(jiffies, timeout)) {
+ dev_dbg(dev, "operation timed out\n");
+ ret = -EINVAL;
+ goto err_tll;
+ }
+ }
+ dev_dbg(dev, "TLL RESET DONE\n");
+
+ /* (1<<3) = no idle mode only for initial debugging */
+ usbhs_write(omap->tll_base, OMAP_USBTLL_SYSCONFIG,
+ OMAP_USBTLL_SYSCONFIG_ENAWAKEUP |
+ OMAP_USBTLL_SYSCONFIG_SIDLEMODE |
+ OMAP_USBTLL_SYSCONFIG_AUTOIDLE);
+
+ /* Put UHH in NoIdle/NoStandby mode */
+ reg = usbhs_read(omap->uhh_base, OMAP_UHH_SYSCONFIG);
+ if (is_omap_usbhs_rev1(omap)) {
+ reg |= (OMAP_UHH_SYSCONFIG_ENAWAKEUP
+ | OMAP_UHH_SYSCONFIG_SIDLEMODE
+ | OMAP_UHH_SYSCONFIG_CACTIVITY
+ | OMAP_UHH_SYSCONFIG_MIDLEMODE);
+ reg &= ~OMAP_UHH_SYSCONFIG_AUTOIDLE;
+ } else if (is_omap_usbhs_rev2(omap)) {
+ reg &= ~OMAP4_UHH_SYSCONFIG_IDLEMODE_CLEAR;
+ reg |= OMAP4_UHH_SYSCONFIG_NOIDLE;
+ reg &= ~OMAP4_UHH_SYSCONFIG_STDBYMODE_CLEAR;
+ reg |= OMAP4_UHH_SYSCONFIG_NOSTDBY;
+ }
+
+ usbhs_write(omap->uhh_base, OMAP_UHH_SYSCONFIG, reg);
+
reg = usbhs_read(omap->uhh_base, OMAP_UHH_HOSTCONFIG);
/* setup ULPI bypass and burst configurations */
reg |= (OMAP_UHH_HOSTCONFIG_INCR4_BURST_EN
--
1.7.4.1
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
