Recent runtime pm and hwmod conversions for 2.6.39 broke the musb peripheral
mode OMAP retention idle on boards where the board mode in struct
musb_hdrc_platform_data is set to MUSB_PERIPHERAL.
These conversions changed the way how the OTG_SYSCONFIG register is
configured and used in runtime. Before 2.6.39 smart standby/idle modes were
activated statically in OTG_SYSCONFIG. Those modes allow that the musb is
able to idle when peripheral device is not connected to host.
In 2.6.39 the OTG_SYSCONFIG is updated runtime depending on VBUS status.
No standby/idle modes are used when device is connected and force
standby/idle when disconnected.
Unfortunately VBUS disconnect event that handles the disconnect case lets
the peripheral musb to idle only when board mode is MUSB_OTG. Fix this by
checking the peripheral mode also.
Signed-off-by: Jarkko Nikula <jhnikula@xxxxxxxxx>
---
For 2.6.39 as this fixes the PM regression on those OMAP3 boards that use
musb in peripheral mode only.
---
drivers/usb/musb/omap2430.c | 2 +-
1 files changed, 1 insertions(+), 1 deletions(-)
diff --git a/drivers/usb/musb/omap2430.c b/drivers/usb/musb/omap2430.c
index 57a27fa..e9e60b6 100644
--- a/drivers/usb/musb/omap2430.c
+++ b/drivers/usb/musb/omap2430.c
@@ -270,7 +270,7 @@ static int musb_otg_notifications(struct notifier_block *nb,
DBG(4, "VBUS Disconnect\n");
#ifdef CONFIG_USB_GADGET_MUSB_HDRC
- if (is_otg_enabled(musb))
+ if (is_otg_enabled(musb) || is_peripheral_enabled(musb))
if (musb->gadget_driver)
#endif
{
--
1.7.4.4
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
