On Sat, Aug 14, 2010 at 4:39 PM, Michal Nazarewicz <mina86@xxxxxxxxxx> wrote: > <http://msdn.microsoft.com/en-us/library/ff537109(v=VS.85).aspx> > specifies that for a device to be identified as composite it (among > other things) "must have a single configuration". The page has also > a passage which seems to indicate that the INF is needed: > >" If you want the generic parent driver to manage your device, but your > device does not have the characteristics necessary to ensure that the > system will generate a compatible ID of USB\COMPOSITE, you will have > to provide an INF file that loads the generic parent driver." > > Selecting of the configuration is also mentioned as a requirement, and > the next paragraph points to a web page you've cited: > >" If your composite device has multiple configurations, the INF file you > provide must specify which configuration the generic parent should use > in the registry. The necessary registry keys are described in > Selecting the Configuration for a Composite USB Device." Thanks. Now it is clear. The patch is correct after all. Somehow I forgot the following blog entry again. This blog entry seems to be more clear than the MSDN entries. http://blogs.msdn.com/b/usbcoreblog/archive/2010/05/19/multi-config-usb-devices-and-windows.aspx +++++++++++++++++ The USBCCGP composite device driver has support for multiple device configurations, with a few caveats. http://msdn.microsoft.com/en-us/library/ff539242(VS.85).aspx 1. USBCCGP will not load on a multi-config device by default because the hub driver doesn't create a "USB\COMPOSITE" PNP ID for a composite device if it has multiple configurations. However, you can write your own INF that matches a device-specific PNP ID to get USBCCGP to load as your device's function driver. 2. To select a configuration other than index 0, you must set registry settings as specified in "Selecting the Configuration for a Composite USB Device". http://msdn.microsoft.com/en-us/library/ff538059(VS.85).aspx During enumeration, USBCCGP will first attempt to select the configuration whose descriptor is found at the specified "original" index. If the attempt fails, normally due to the configuration requiring more than 100mA while the device's upstream hub has only bus power, then USBCCGP attempts to select the configuration found at the specified "alternate" index instead. 3. Drivers that are clients of USBCCGP cannot change the device's configuration value. +++++++++++++++++ -- Xiaofan -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
