Hi Akash,
I was planning to, but the project was terminated so there was no budget to
finalize it. You're free to take over and make the required changes.
M.
On 21-11-2024 09:34, AKASH KUMAR wrote:
Hi @Mike
Do you have plans to mainline this change?
We are using microchip hub in one of our project and we need this driver,
we have taken your change and able to enable usb hub.
Please check if you can push updated patchset addressing the comments from Rob.
On 5/22/2023 1:58 PM, Rob Herring wrote:
On Mon, 22 May 2023 09:45:09 +0200, Mike Looijmans wrote:
The USB5807 is a 7-port USB 3.1 hub that can be configured by I2C.
This driver resets the chip, optionally allows D+/D- lines to be
swapped in the devicetree config, and then sends an ATTACH command to
put the device in operational mode.
Signed-off-by: Mike Looijmans <mike.looijmans@xxxxxxxx>
---
Changes in v3:
Add minItems
Changes in v2:
Rename to microchip,usb5807.yaml
Remove reset-gpios description
Add maxItems
Add vddXX-supply properties
.../bindings/usb/microchip,usb5807.yaml | 58 +++++++++++++++++++
1 file changed, 58 insertions(+)
create mode 100644
Documentation/devicetree/bindings/usb/microchip,usb5807.yaml
My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check'
on your patch (DT_CHECKER_FLAGS is new in v5.13):
yamllint warnings/errors:
dtschema/dtc warnings/errors:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/usb/usb251xb.example.dtb:
usb-hub@2d: swap-dx-lanes: size is 32, expected 8
From schema:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/usb/usb251xb.yaml
doc reference errors (make refcheckdocs):
See
https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20230522074510.16367-1-mike.looijmans@xxxxxxxx
The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.
If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:
pip3 install dtschema --upgrade
Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.
Thanks,
Akash
