On Mon, 22 May 2023 09:45:09 +0200, Mike Looijmans wrote: > The USB5807 is a 7-port USB 3.1 hub that can be configured by I2C. > This driver resets the chip, optionally allows D+/D- lines to be > swapped in the devicetree config, and then sends an ATTACH command to > put the device in operational mode. > > Signed-off-by: Mike Looijmans <mike.looijmans@xxxxxxxx> > > --- > > Changes in v3: > Add minItems > > Changes in v2: > Rename to microchip,usb5807.yaml > Remove reset-gpios description > Add maxItems > Add vddXX-supply properties > > .../bindings/usb/microchip,usb5807.yaml | 58 +++++++++++++++++++ > 1 file changed, 58 insertions(+) > create mode 100644 Documentation/devicetree/bindings/usb/microchip,usb5807.yaml > My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check' on your patch (DT_CHECKER_FLAGS is new in v5.13): yamllint warnings/errors: dtschema/dtc warnings/errors: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/usb/usb251xb.example.dtb: usb-hub@2d: swap-dx-lanes: size is 32, expected 8 From schema: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/usb/usb251xb.yaml doc reference errors (make refcheckdocs): See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20230522074510.16367-1-mike.looijmans@xxxxxxxx The base for the series is generally the latest rc1. A different dependency should be noted in *this* patch. If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date: pip3 install dtschema --upgrade Please check and re-submit after running the above command yourself. Note that DT_SCHEMA_FILES can be set to your schema file to speed up checking your schema. However, it must be unset to test all examples with your schema.
